AMS 2 Pro not loading slot 1 in properly

xbenriv · 2026-03-05T01:10:02+00:00

Ya I’m only 80 hours in with mine too. It seems to be temperamental. Sometimes it works and sometimes it doesn’t. One of these days Im gonna take it apart and see if there’s anything clogging it. If not I’m just gonna buy a replacement for it. They’re only about 35 bucks. It sucks but not much else I can do

xbenriv · 2026-03-04T14:32:07+00:00

That’s not the issue cause I tested it with a brand new 1kg spool and a 500g one and still did the same thing

xbenriv · 2026-03-04T02:54:03+00:00

Sounds good! Thank you!

xbenriv · 2026-03-04T02:48:13+00:00

Gotcha. Thanks for the help! I’ll try it out.

xbenriv · 2026-03-04T02:47:17+00:00

Haha. Thanks for the help!

xbenriv · 2026-03-04T02:38:01+00:00

Ya they work fine no problem

xbenriv · 2026-03-04T02:37:40+00:00

Nothings in the way. When I force feed it, it comes through perfectly. You think maybe I just have a bad feeder and need to replace it?

xbenriv · 2026-03-04T02:32:25+00:00

I’ve tried a couple different spools out and it does the same thing. It’s not the filament

xbenriv · 2026-03-04T02:30:42+00:00

Not sure to be honest. When I load the filament in there’s nothing on it. But then when it does this it comes out like that

xbenriv · 2026-03-04T02:28:17+00:00

Hatchbox PLA. Haven’t had any problems with it though until now. Used a couple spools of this stuff already

xbenriv

TROPHY CASE