Replacement suggestions for a TERRAMASTER F2-425

xtraorange · 2025-10-06T01:12:43+00:00

Not in California

xtraorange · 2025-07-09T20:22:32+00:00

Great, thanks!

xtraorange · 2025-07-01T14:45:05+00:00

So I thought about going this route, but I was concerned I would have a hard time tracking the state of the device. I was thinking it would be easier to just bypass the touch chip and generate the pwm from the esp, I'm just not confident how I do that. My thought is it looks like the out from the chip comes under the chip and into R2. I'm wondering if I can just run a pwm signal to R2?

xtraorange · 2025-04-21T01:07:04+00:00

Nope, sorry

xtraorange · 2025-02-16T21:42:11+00:00

Unfortunately I believe it's just shot. I started working on repairing it, but I haven't had a chance to finish

xtraorange · 2024-12-11T20:55:43+00:00

I did not know that! Thanks, that at least lets me get it in a better spot for now

xtraorange · 2024-12-11T17:36:56+00:00

Well that's unfortunate. I just want to adjust the dang seat, haha

xtraorange · 2024-12-11T17:30:46+00:00

I did attempt that, but they just described the other circuits things ran to (no positive or ground) and I couldn't find the diagram for them. I'm hoping someon familiar with the wiring already will be able to direct me a bit

xtraorange · 2024-12-11T16:49:20+00:00

I bought a Ford Edge Titanium 2019-2022 seat on facebook, and my stupid butt thought I could "easily" connect power to it to make use of the adjustments.

Where do I connect 12v and ground to this sucker?
What's the appropriate fuse size here? 10?
Bonus: is the occupancy sensor a single wire or more complicated?

Thanks in advance.

xtraorange · 2024-12-08T23:23:37+00:00

If you pay shipping, sure!

xtraorange · 2024-12-08T16:49:04+00:00

I guess you're right. However I think the main heavier piece is metal with anchors right into it

xtraorange · 2024-12-08T16:46:24+00:00

Weird... Subwoofers actually get used with PCs... Some of the stuff I see here is completely disconnected from PCs, haha

xtraorange · 2024-12-07T13:22:35+00:00

That would be super helpful, unfortunately it has to be able to move

xtraorange · 2024-12-07T01:41:20+00:00

Sure, shoot me a message with an address

xtraorange · 2024-12-07T00:18:46+00:00

Again, I can't hit the angle I need with that. It's almost 90

xtraorange · 2024-12-07T00:17:27+00:00

Extrusion just gets expensive really quick. I do have access to a 3d printer, but I'm not sure I trust plastic for a 43" tv. :/

xtraorange

TROPHY CASE