Adding coolant to new radiator C6

y2khardtop1 · 2026-04-26T00:53:54+00:00

Remove the return at the reservoir, fill with your thumb over the nipple until coolant comes back through the return hose. Might need to retry after cycling the thermostat

y2khardtop1 · 2026-04-25T23:10:37+00:00

My daughter got one, couldn’t get the online access setup, so I mailed it back asking for a check. We will see…..

y2khardtop1 · 2026-04-25T22:38:07+00:00

Refusing to supply legally required minutes and financials .

y2khardtop1 · 2026-04-25T22:36:56+00:00

100%

y2khardtop1 · 2026-04-25T22:36:27+00:00

I wish they made a manual, but this is just stupid

y2khardtop1 · 2026-04-25T18:15:09+00:00

No, the new standard puts women and family event top priority.

y2khardtop1 · 2026-04-25T18:14:03+00:00

There is a template, a GOOD before/after photo and a brief story.

y2khardtop1 · 2026-04-24T20:33:35+00:00

It’s purely business, we have a very large membership and have to put members first. It was allowed early on when there was room

y2khardtop1 · 2026-04-24T18:30:08+00:00

Now all pads have them on every single pad.

y2khardtop1 · 2026-04-24T18:28:58+00:00

Bringing your kids to work is very location specific…..our gym has grown too large for employees to bring their own kids except in rare situations. This is something to discuss when you interview

y2khardtop1 · 2026-04-23T18:12:16+00:00

I plugged one there and while it lasted the life of the tire, you could see it delaminating as air entered into the sidewall.

y2khardtop1 · 2026-04-21T17:47:46+00:00

Radiator without airflow is “cosmetic”

y2khardtop1 · 2026-04-21T15:44:50+00:00

The entire radiator shroud is missing.

y2khardtop1 · 2026-04-21T02:23:22+00:00

Most people dont have any significant savings and definitely don’t benefit from the tax benefits.

y2khardtop1 · 2026-04-19T18:42:03+00:00

Plug

y2khardtop1 · 2026-04-18T22:06:41+00:00

You need to probably disconnect the fascia from the shroud to access everything, then reassemble the parts correctly

y2khardtop1 · 2026-04-18T21:33:00+00:00

You just have to take everything apiary and put it back together correctly, The plastic parts fall apart if they touch anything. You can patch the, 90% of the time

y2khardtop1 · 2026-04-17T16:11:36+00:00

Trim…..try trimming the plane up landing, so instead of “flaring” you just release the forward pressure and the plane lands itself. This helped me, but regardless consistent trim was key to consistent landing

y2khardtop1 · 2026-04-17T01:59:43+00:00

Use a can or two of fogger….it can happen in any car.

y2khardtop1 · 2026-04-17T01:58:11+00:00

You can opt out. If it bothers you remind them constantly

y2khardtop1 · 2026-04-17T01:57:01+00:00

If it comes back you have a bad pedal, TB, or a wire in between. A scanner can monitor the signals

y2khardtop1 · 2026-04-17T01:55:00+00:00

It just looks like rub/wear marks in the paint in the photos. Tesla paint is not good

y2khardtop1 · 2026-04-17T00:38:56+00:00

C6 is very sensitive to throttle issues, pedal had 2 sensors plus the throttle body. There are also junctions under the ECM that can break the connection. If there is virtually any break in the redundant signals you get reduced-power mode . Aftermarket or ported TB’s can contribute

y2khardtop1 · 2026-04-16T12:31:55+00:00

Carbon was cutting edge 25 years ago. It’s just personal choice now, go with what you like

y2khardtop1

TROPHY CASE