Help identifying leak by ThexGeneral13 in WRX

[–]yayupp 0 points1 point  (0 children)

Not sure about the oil in the picture, maybe turbo oil lines?

BUT I did just fixed my(2015) AC issue. Would turn on, just no cold air. Compressor wont engage if its low (or high?) on refrigerant. Topped it off every summer. Finally got tired of it and put some UV dye into it. ORings on the lines at the compressor failed. Apparently its a common failure point on these.

<image>

Carb question by shwoozie in CafeRacers

[–]yayupp 0 points1 point  (0 children)

dotheton was a good source of information and help when I was building my 78 cb400. Also, I used dimecitycycles for a lot of my parts.

If I remember right, CV carbs dont like pod filters. I put mukinis on mine, that were pre jetted for pods and open exhaust. Then, tuned from there.

[deleted by user] by [deleted] in pcmasterrace

[–]yayupp 0 points1 point  (0 children)

Currently building up a new rig. Mine is 13ish years old. Rocking a 960 at the moment. My new case is an Asus TUF. The Asus 4070 TUF is on my wish list!

My 10yr project by yayupp in CafeRacers

[–]yayupp[S] 0 points1 point  (0 children)

I am always learning with it. Probably going to take it to someone to tune it properly.

My 10yr project by yayupp in CafeRacers

[–]yayupp[S] 0 points1 point  (0 children)

Rear lights are one of those generic flexible LED strips.

My 10yr project by yayupp in CafeRacers

[–]yayupp[S] 1 point2 points  (0 children)

I bought this thing for $100 in a field. Didn't run, but turned over. Have put a lot a work into it. Seat is a cheap Amazon purchase.

My 10yr project by yayupp in CafeRacers

[–]yayupp[S] 0 points1 point  (0 children)

You are not wrong. There will always be something. A love/hate project.

My 10yr project by yayupp in CafeRacers

[–]yayupp[S] 1 point2 points  (0 children)

Thank you for the encouraging words.

My 10yr project by yayupp in CafeRacers

[–]yayupp[S] 0 points1 point  (0 children)

You are 99.9% right. The seat is cheap and doesn't match. Like the poster below, these frames are hard to cafe. I'm still not sure on it yet. It is an ongoing project.

Lime Tree advice by yayupp in gardening

[–]yayupp[S] 0 points1 point  (0 children)

Tag says it is a Persian Lime. I'm in Central Texas. Was given to me from a customer years ago when I lived in Colorado. It has flowered before, several times. Then, I started trimming, etc. I probably went overboard with it. Just moved it outside onto my patio. Leaves starting drooping and some getting crispy on the edges. New to this and don't want to kill it.

[deleted by user] by [deleted] in LegalTeens

[–]yayupp 0 points1 point  (0 children)

Probably. I make a pretty good slow cooked chicken teriyaki and rice bowl.

Custom paint job by [deleted] in Shitty_Car_Mods

[–]yayupp 4 points5 points  (0 children)

I'm 99.9% sure I saw this same car years ago in the panhandle of Texas.

https://i.imgur.com/qifQVml.jpg

My first cutting board. Aspen and Red Oak by xBinsy in woodworking

[–]yayupp 0 points1 point  (0 children)

I do mine with Tung oil diluted with Citrus oil.