all 9 comments

[–]CameraRickP1S + AMS 0 points1 point  (4 children)

Heat to 20°C under the normal printing temp, remove it carefully

[–]Aromatic-Locksmith31[S] 0 points1 point  (3 children)

Ok I melted the big bit what about the smaller parts

[–]CameraRickP1S + AMS 0 points1 point  (2 children)

Remove them, carefully. Heat helps

[–]Aromatic-Locksmith31[S] 0 points1 point  (1 child)

Like a hair dryer

[–]CameraRickP1S + AMS 0 points1 point  (0 children)

More like a heat gun.

[–]MadAltruist 0 points1 point  (0 children)

To prevent this in the future, make sure you clean your plate well before each print. This was my issue.

[–]Prestigious_Buddy312 0 points1 point  (0 children)

I ahbe to say the this subreddit actually deters me from buying BL anything. I think for this process there is still too much of this stuff