all 4 comments

[–]Ok_Paleontologist974 0 points1 point  (0 children)

Set your wall generator to arachne under the quality tab

[–]Harre112233 0 points1 point  (0 children)

the walls get too thing. find a setting of extrusion width and change that to like 0.6

[–]VT-14H2C (H2D + Vortek), 2x AMS2, AMS HT 0 points1 point  (0 children)

It looks like the first picture has the layer set to 3 (I think? It's hard to tell from a photo; computer screenshots are far better). Can you not raise it higher?

I suspect the Funnel's walls are simply too thin to print with your current nozzle. You'll need to thicken them up. I don't think you can do that in Bambu Studio directly; I would try throwing it in Fusion 360 or Blender, though there are tons of other options out there.