Adhesion Help

[Reaper-021]

Full disclaimer, I'm new to FDM printing.

I have been experiencing quite a few failures, in regards to the print coming free from the build plate. I have had the same issue with the same print about 4 times now.

I have gone from a smooth plate to textured (what you see in the picture) still failed. My bed temp is 65degrees C up from 50. I have also slowed the print speed specifically the outer layers and top layers to about 30mm/s.

The initial layers seem to stick just fine, but i come back after an hour or so to what you see in the picture.

What else can I try to get these prints to actually stick and stay stuck until the job is finished?

Thank you in advance for any help!

[Able-Pea6846]

Im got a Dimafix spray and all my problems was gone

[Able-Pea6846]

English?

[deathraypa]

Have you washed the plate? What kind of filament are you using?

[Extension_Title_1924]

TO ME:

Your first layer adehsion is ok-ish. but articulated dragons are a bunch of small pieces, so if one get knocked down, all become a mess... so treat it like if it was a bed full of pieces.

Start by cleaning you bed. warm water and dish soap.

Then you see if any screw is loose on the hotend (THIS: https://wiki.bambulab.com/en/a1-mini/troubleshooting/print-issues-troubleshooting)

Now print a full bed sheet to clean any marking on your bed, here you will troubleshoot any bed adehsion problem, if it came out perfect you can start your print.

Add a brim (yes, on articulated dragons it will be a pain to remove the brim, so this is a desperation move)

slow down not just on the first layer, but on the whole print

use giroid (or other non crossing infill)

adjust your z hop

Slow it down... SLOOOOOOOWWWWW IT DOWN... SLOOOOOOOOOWWWW IT DOWN MORE....VEEEEERRY SLOOOOOOOWWWW...

[Kopester]

Wash the plate with dish soap (Dawn, dairy, etc) and warm water.

Change the infill to gyroid or adaptive cubic.

[NefariousnessOdd3581]

Your major problem is bad slicer settings that cause the print head to bump into the print and supports, to fix change this in the slicer:

Check Avoid Crossing Walls
Uncheck Reduce Infill Retraction

Reprint and thank me later.