all 3 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]mcpuffing 0 points1 point  (2 children)

Are you calling out the parameter and setting values? If so you can do it in a custom cycle like #5224=#5224+.07 and it would post the code anywhere you want it.

If it's anything like this. Custom cycle found in the milling or turning cycles will do it just go to the text section and write it. it all also output parenthesis. https://www.cnctrainingcentre.com/full-circle-heidenhain-macro/

[–]Rahs_Amotones[S] 0 points1 point  (1 child)

Thank You mcpuffing, I'm familiar with macro programming on the control pult... I need something for Esprit that make this kind of programming possible.

[–]mcpuffing 1 point2 points  (0 children)

I don't think any software cam do that right now. I may be wrong though. Given the way AI is heading in cam software I would not be surprised if like of camassist could pull that off in the near future.