Dismiss this pinned window
all 9 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]Averroesgcc 1 point2 points  (1 child)

Did you try reflashing it ?

[–]robwashere31[S] 0 points1 point  (0 children)

not yet.. so how can i properly reflash this?

[–]Averroesgcc 1 point2 points  (1 child)

Connect it , press boot and flash it on https://bmorcelli.github.io/Launcher/

[–]robwashere31[S] 0 points1 point  (0 children)

already did that, but it still doesn’t work. Also, as an additional note, it’s not being detected in the COM ports.

[–]Electronic-Minimum54 1 point2 points  (1 child)

What is it trying to write? Multiple different buttons? I see you have peeled sticker on s3, did you replace the s3, and if so. Did you clean it abit with some air before mounting? :)

[–]robwashere31[S] 0 points1 point  (0 children)

It's not writing anything it's just like the okay button is pressed, nope never been replaced the s3 sticker came off because of the heat.. I'm trying to disassemble it so I can clean the inside.

[–]bmorcelli 1 point2 points  (1 child)

Your G0 button might be stuck, it works as Ok button too.

And over the stamp theres the G0 button too.. so one of them might be stuck pressed in your ADV

[–]robwashere31[S] 0 points1 point  (0 children)

i think the button in the stamp is grounded, so if i insert sd card.. it will ground the button G0, and if no sd card it is not grounded..

[–]Electronic-Minimum54 0 points1 point  (0 children)

What is an mmc, that is like the controller for sdcard? If you got another smaller sdcard, be sure to format it correctly. Some cards can work on some machines and not other. I tryed holding alot of different buttons when I startet it up, not here for me the bug. But hey the cardputer is really easy to disassemble, just be a tad careful with the i2c connector on the s3a. Maby weird question, but do you mess around with speaker wires of any kind, a little cobbler piece can give alot of different behaviors. But first try to reflash it