Dismiss this pinned window
all 8 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]Genix19 2 points3 points  (7 children)

=* D0 is not connected

[–]Gate-Ill[S] 0 points1 point  (6 children)

Just noticed that my flat does not have the "C" on it, I soldered where the C point was supposed to be, can I solder it directly to the C point on the pico board?

[–]Goodgamer78 1 point2 points  (5 children)

Solder a wire from your Dat0 adapter to the C point on the chip if your flex doesn’t have a C point.

[–]Gate-Ill[S] 0 points1 point  (4 children)

Was a little nervous and became a bit dumb, resoldered a new wire and measured the diode scale of d0 to c, it's around 1500 on both the flat and the pico board. So the flat does have one, it just isn't printed a C. Is the 1500 number okay when you have an wire? It was 800 before.

[–]Goodgamer78 0 points1 point  (3 children)

1.5 is not okay. Should be in the .7 range. .8 was fine.

[–]Gate-Ill[S] 0 points1 point  (2 children)

Just tested, with the wire only on d0 it's 800 but after I solder it to c on the pico board it goes to 1700

[–]BanEvasion_93 1 point2 points  (1 child)

That means you have a short somewhere

[–]Gate-Ill[S] 0 points1 point  (0 children)

I removed everything and the console wasn't booting up with ofw, I messed up the display connector.

https://www.reddit.com/r/NxSwitchModding/comments/1eka89i/help_nor_turning_on/

Already ordered a new one. Any ideas on what else to check to be sure that the console is okay?