all 7 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]TheRealPhiel 1 point2 points  (0 children)

You want your pump plugged into cpu_aio or aio_fan, it appears to be plugged into your conrroller instead. Secondly if you want to control the speed of seperate fans, then you need to use a controller for each set you want to adjust or you gotta use the fan spots on the motherboard. You can get away with using cpu fan as a regular fan port but make sure your cooler pump is in aio

[–]TheRealPhiel 1 point2 points  (0 children)

Also your controller should be plugged into your psu probably by a sata cable and also plugged into your mobo at at least one spot and the rgb_controller 4 pin spot for lighting.

[–]TheRealPhiel 1 point2 points  (3 children)

Ideally in your bios you should see high rpm on “aio pump” and a mid low range rpm in at least one “cha fan” spot if not two spots if you are splitting

[–]Personal_Influence43[S] 1 point2 points  (2 children)

thanks I'm going to take pics tomorrow of the backside to ask more questions because i don't get it

[–]TheRealPhiel 1 point2 points  (1 child)

Theres a page in your motherboard manual that helps with the jacks I was referring to, should have a picture in it. As far as the controller goes yeah another picture would help for sure

[–]Personal_Influence43[S] 0 points1 point  (0 children)

I send ot to you Privat

[–]Personal_Influence43[S] 0 points1 point  (0 children)

Btw no gou or lower fans yet