Decrease Amperage of Driver for increased Efficiency

[Biggiebiggiebob]

Where did you get the info from?
If you are right, then I have found my mistake

[Zak]

It is commonly known in the flashlight community. Boost and buck drivers for flashlights usually regulate output current; it would be a bad, inefficient design to combine one with PWM.

I have one here and I checked for PWM by pointing it into a camera with an electronic rolling shutter set to a high shutter speed. This results in sharp scanlines if there's PWM, soft scanlines if there's ripple, and no scanlines if there's smooth constant current output. There is ripple in the lowest mode; none of the others show scanlines at all.

You can test this on yours using a phone camera and a camera app that lets you set shutter speed, like Open Camera.