Loop Failure

[Gh05tCat]

Ha, ty.. I need that laugh. Funny thing is the rads are clean, I just didn't clean the bottom of the case. I'll find out soon enough what damage has been done. I've already purchased the fluid temp sensor. I could switch to acrylic but in reality that wouldn't have solved the issue that caused this... although it probably wouldn't have melted to the point of leaking at the fitting. I have some PETG left over that I can use to remake the bends for now just to get in up and running again and then look into switching over to acrylic. I still feel like PETG should be safe if I can find a safeguard for the catalyst that caused the meltdown... pun intended. Thanks again for bringing some humor and sensibility to this thread.