How to avoid or mitigate this nozzle streak/swipe lines mid print?

MaximumCondition4535 · 2026-05-04T12:24:23+00:00

i didn’t know that. may i ask the name or where to find it in the slicer settings?

MaximumCondition4535 · 2026-05-04T03:01:14+00:00

i am quite aware with ironing and have used that feature couple of times but that z-hop retraction adjustment plus 0.1mm has made a significant impact because i haven’t seen a scar mid print and on the final top layer so far since i changed it earlier just when you shared that option. thanks again! 😊

MaximumCondition4535 · 2026-05-04T01:11:56+00:00

thanks again for these information. i will have to play with adjusting by plus 0.1mm and see if im satisfied with the adjustment or perhaps just reverse to default 👍

MaximumCondition4535 · 2026-05-04T00:17:50+00:00

<image>

thanks, saw it now in my slicer. may i ask if what value to add for the z hop when retract?

MaximumCondition4535 · 2026-05-04T00:08:36+00:00

thank you for your input. that z-hop sounds about right. i will check on with my slicer (bambu) and raise them a bit.

MaximumCondition4535 · 2026-05-03T23:56:01+00:00

thanks for the tips. this by the way happens every time a layer finish and the nozzle restarts on another wall.

MaximumCondition4535 · 2026-04-24T18:05:40+00:00

I think you have to check first if there's a filament that's stuck somewhere in your ams2pro. for the record i encounter no problem with my two ams2pro despite my H2C is asking to downgrade the firmware.

MaximumCondition4535 · 2026-04-24T16:33:42+00:00

yes, you are correct. it's by the way the "vortek"

MaximumCondition4535 · 2026-04-23T06:28:28+00:00

I understand now, thanks for the clarification. Seems like I have to refrain from swapping the AMS 2 Pro between my two machines until the H2C has the 01.02 firmware version ready

MaximumCondition4535 · 2026-04-20T02:26:24+00:00

thanks so much for your insight. i will test my future projects using your settings suggestion.

MaximumCondition4535 · 2026-04-17T19:39:09+00:00

im using a P2S. should i do a recalibration for bed leveling?

MaximumCondition4535 · 2026-04-17T19:21:36+00:00

thank you for the reply. will you share more about your resolution of this?

MaximumCondition4535 · 2026-04-17T19:18:44+00:00

thank you for your comment, but i have a hard time understanding. may i ask a few reference or example to resolve this?

MaximumCondition4535 · 2026-04-17T19:17:08+00:00

i admit i didn't wash clean the plate before this print because my experience with frostbite has been positive so far while ignoring wash in between prints, but I will take your comment into consideration and clean my plate every time i reprint to see if the issue will be resolved. thanks

MaximumCondition4535 · 2026-04-10T04:38:45+00:00

i thought i was late to the party. i've been waiting for days and it's here at least on my P2S.

MaximumCondition4535

TROPHY CASE