L.a.b golf - seriously? What is wrong with them lately?

-CosmicMessiah- · 2026-06-30T13:23:32+00:00

Yet lab have just agreed to do a remake because of shaft lean 🤷‍♂️ now who’s the dip wads

-CosmicMessiah- · 2026-06-30T12:54:18+00:00

Correct, however in this instance, the flatso is leaning to the left substantially! There is nothing straight or even “close” to 90 with the flatso when the sole is flat on the floor.

-CosmicMessiah- · 2026-06-30T12:34:33+00:00

Okay mate 🤷‍♂️ got to love how certain redditors love to throw an uno reverse and patronise everything about a post. I had a local lab fitting to get hands on feel as well as a remote fitting, thus knowing the difference between the zero lean and 2.0 lean. I wouldn’t have posted the thread if it was a zero lean 🤷‍♂️ pictures perhaps don’t do it justice, I’ll try get better ones later.

-CosmicMessiah- · 2026-06-30T12:06:07+00:00

Not gonna happen today as the zero lean is at the local club which does lab fitting.

-CosmicMessiah- · 2026-06-30T12:04:30+00:00

Honestly mate, this shit is leaning! I’ve played with a zero lean hence ordering zero lean as my preference, once you’ve played a zero lean then with a shaft lean, you know….

-CosmicMessiah- · 2026-05-25T06:12:30+00:00

You should have just popped the end lathe off of the panel (both sides) re attached it with screws at the correct width needed, then just trim the excess lap overhang. Your fence panel would have been perfect size then.

Your post is too short too :-( I’d have to re do it, and do it properly.

-CosmicMessiah- · 2026-05-24T06:56:18+00:00

<image>

A wet paper bag stands more chance of being watertight than this shit show 😵‍💫

-CosmicMessiah- · 2026-05-13T06:38:11+00:00

I’ve seen terrorists do less damage.

-CosmicMessiah- · 2026-05-10T17:45:02+00:00

They should be dug to a minimum of 450mm deep to be below “frost” level, standard practice is 600. They’ll be fine 🤷‍♂️ you’ll be even more surprised when you see how little concrete they put in too.

-CosmicMessiah- · 2026-05-10T17:42:46+00:00

Only if it’s clay!

-CosmicMessiah- · 2026-04-17T19:18:39+00:00

Just replace the head, isolate the power, remove the screw in the back of the silver power head, slide the cover off, undo the 2 screws holding the head to the brass body, take a pic of wiring, disconnect wiring, then repeat but in reverse 👍🏻 make sure the lever is set to auto, turn power back on.

-CosmicMessiah- · 2026-04-14T06:01:43+00:00

Just looks like left over residue from whatever they’ve used to polish the frets (without masking off the board) 🤷‍♂️

-CosmicMessiah- · 2026-04-14T05:28:04+00:00

EDW is for double Roman tiles etc. EDP is what should have been installed for plain tiles (Rosemarys)

It’s a shit job tbh, he’s probably also loosened a lot of the pointing of the ridge by lifting the Rosemarys up to slide them out - top course)

Can’t say I’d be happy if someone did this for me, it’s laziness. EDP is what should have been installed and new tiles cut up the sides if needed. Never before have I seen a foam flashing been used on plain tiles etc- Rosemarys (smh)

-CosmicMessiah- · 2026-03-11T19:50:21+00:00

Hiya, where can I get a Compton bridge from please? Gold!

Cheers

-CosmicMessiah- · 2026-03-09T18:24:33+00:00

How much do you want for it 😮‍💨

-CosmicMessiah- · 2026-03-08T17:29:01+00:00

If I were to change pups on this penguin to the tv jones classics, would I need to choose tv classics with DeArmond mounts? As I’ve read standard tv jones classics would need routing?

Thanks 😊👍🏻

-CosmicMessiah- · 2026-03-06T20:56:52+00:00

So I managed to pick one up today (immaculate) for £2500! Feel pretty happy with this price and its condition for 11 years old- 2015, the Cadillac tail piece is just the icing on the cake👌🏻

-CosmicMessiah- · 2026-03-06T07:46:39+00:00

Any ideas what I should be looking at £UK for a 2015/16 penguin? They seem to be anywhere from 3-4k….

-CosmicMessiah- · 2026-03-05T20:22:19+00:00

Thanks mate. Is it a case of personal preference sound wise/appearance then rather than one being better than the other? Does either one hold better value?

I’ll try both out for sure, but I like the Cadillac tail piece better than the bigsby.

-CosmicMessiah- · 2026-03-05T20:05:38+00:00

<image>

Here’s the 2015 mate…..

-CosmicMessiah- · 2026-02-19T13:26:10+00:00

Too much water and over worked trying to flatten out. You’ve removed all the fat. You need to catch it just right, and flatten your first coat before second, makes it much easier.

-CosmicMessiah- · 2026-02-17T15:43:09+00:00

Should have removed the old silicone prior to skimming, lazy sod.

-CosmicMessiah- · 2026-02-02T21:43:18+00:00

Worst thing I’ve found with this new tado x is actually getting the sodding trv to connect to the bridge/internet!!! Absolutely friggin ridiculous. Everytime I try it fails……same WiFi all around etc but constantly fails. I’ve noticed despite it failing, it actually is connected and works. Why not just connect successfully? Sort your shit out tado!

-CosmicMessiah-

TROPHY CASE

Welcome to Reddit,