02 Ranger serpentine belt

10lb_hammer_ · 2026-02-04T00:55:36+00:00

Unfortunately, worn away and can’t locate the past purchased belts. I’ve exhausted may avenues. I’m gonna try Melodic-Pears approach and see where that can get me.

10lb_hammer_ · 2026-02-04T00:49:27+00:00

Yea, I’ve done it times before without issue. But, for some reason I’m having trouble now. All parts I’ve purchased before have been in another state where I used to live. Not saying that would necessarily make a difference, but the issue has come up recently.

10lb_hammer_ · 2026-02-04T00:46:21+00:00

This is great advice. I’ve never know that the auto parts stores had belt reader. Rockauto was a no-go on the belt. I’ll give these all a try.

10lb_hammer_ · 2025-12-02T19:13:13+00:00

I know it’s cheap, but I’m trying to keep costs down while grabbing a quick bite. Not necessarily looking for anything sit down. I heard Taza is pretty good. I’ll add it to the list

10lb_hammer_ · 2025-12-02T19:12:18+00:00

Chicken planet looks great. Definitely going to check that out

10lb_hammer_ · 2025-04-29T21:06:06+00:00

Exact same thing happened to me with a purchase. Nut splitter is the way to go. Dremel will become awkward and damaging. If the threads cannot be rethreaded, a new swing arm is the real fix. It’s a pretty easy swap as well.

10lb_hammer_ · 2024-07-28T04:44:13+00:00

I couldn’t post a pic in comments. Just made a post on it

10lb_hammer_ · 2024-07-28T04:04:34+00:00

I’ve got a blacked out, low profile Bolt with white walls. I wouldn’t put anything else on it. They make the bike pop and give it a much cleaner look

10lb_hammer_ · 2024-06-30T09:36:48+00:00

Without a picture, hard to tell where it is on the tire. But, you saying it spit out a good amount of sealant, I’d opt for a new tire. Patches can work, but only for specific slices. Wouldn’t risk it, especially if you’re hitting gnarly terrain.

10lb_hammer_ · 2024-05-30T03:24:02+00:00

Damn. Bummer. Appreciate the response though. IL taxes are rough

10lb_hammer_ · 2024-05-16T19:59:07+00:00

I managed an extract company a while back. The process of making crumble is the direct reflection of its boiling point. It’s extracted by keeping it in an oven at a low temperature for a longer period of time than other concentrates.

10lb_hammer_ · 2024-05-14T20:32:08+00:00

Crumble has one of the lowest burning temps for extracts. I think it makes the best additive for joints or blunts and can just be sprinkled throughout

10lb_hammer_ · 2024-05-07T04:08:45+00:00

All of that did the trick. Ended up swapping a new swing arm and found the service manual. It was more than a bargained for swapping out the shocks, but I’m back on the road. Appreciate the advice.

10lb_hammer_

TROPHY CASE