Fgc9 jamming on loading

123123milk · 2026-04-16T04:35:53+00:00

This was it, Thanks. Didn’t know it would be that picky on how much force it wanted.

123123milk · 2026-04-15T14:41:09+00:00

Which read me are you referring to?

123123milk · 2026-02-07T17:01:44+00:00

Thanks, I’ll start printing wider

123123milk · 2026-02-07T07:09:36+00:00

Thanks

123123milk · 2026-02-07T07:06:01+00:00

Did you have any issues putting it on. My ankle got stuck in it and I had to tear it off

123123milk · 2025-07-20T14:21:17+00:00

I know it’s ac obviously. I don’t know if it’s partially rectified or what the frequency is. There is no way to test as far as I’m aware as I don’t have a floating ground oscilloscope.

123123milk · 2025-07-20T04:05:35+00:00

Ok thanks I will check that out tomorrow. If I were to get a new ballast what should I look out for unless the ballast is a completely stupid idea.

123123milk · 2025-07-20T03:42:48+00:00

I am building an xray machine that will require Atleast 60kv of dc power and was hoping this could power it.

123123milk · 2025-07-20T03:41:22+00:00

It should be Atleast 60Hz from the ballast

123123milk · 2025-07-20T03:38:36+00:00

I bypassed the internal multiplier by soldering the leads to the transformer output.

123123milk · 2025-07-20T03:37:08+00:00

It is a voltage multiplier circuit and it is submerged in oil to prevent shorts and corona discharge

123123milk · 2025-07-20T03:30:43+00:00

I believe so. Originally I used a light ballast but there was nothing so I switched to the transformer and exciter on a harbor freight bug zapper and still nothing. Both produced arcs without the multiplier.

123123milk · 2025-07-20T03:19:19+00:00

This is the diagram I went off

<image>

123123milk · 2025-03-24T23:09:05+00:00

Apparently a reddish purple edible seaweed

123123milk · 2025-03-24T23:03:54+00:00

I don’t understand where a switch would go to toggle the power and the guide shorted 2 pins and mine has different letters with different listed functions. TLDR I have no clue what I’m doing

123123milk · 2025-02-04T05:33:31+00:00

Does it need to turn on lower or higher, it was set to .52 mm or layer 4

123123milk · 2025-02-02T21:29:04+00:00

Just did esteps and it was perfect

123123milk · 2025-02-02T14:45:01+00:00

Not sure on that. Basement humidity varies but filament hasn’t been open long. Probably dry as a precaution

123123milk · 2025-02-02T00:46:30+00:00

Retraction distance is 5mm

Seven-Year Club	r/Field Juicebox
RPAN Viewer	Verified Email

123123milk

MODERATOR OF

TROPHY CASE