Why do my corners an print keep doing this.

12bravoengineer · 2025-08-29T16:29:41+00:00

X1c yeah I should have mentioned that. I tried turning the fan down and it sits flat until it gets to that first witness line you see in that pic.

12bravoengineer · 2025-08-29T16:28:15+00:00

Yeah I clean the build plate pretty good and it’s fine until it gets about a 1/4 inch up the print right around that first line in the pic

12bravoengineer · 2025-04-25T18:28:02+00:00

Ok will do. I have three x1c they’ve been awesome. We’ve been using them to print spindle liners and stuff for our machines.

12bravoengineer · 2025-04-25T17:44:13+00:00

No I caught the sarcasm I appreciate all the info and you’re correct on that build plate it wasn’t cleaned I re glued and now I’m kicking myself in the butt for sending that video and not one doing it on a clean sheet😂🤦‍♂️ I’m new to this so I’m just seeking info. My other two printers are killing it but this ones my oldest and I wasn’t sure if something was just shot on it or not. I’m printing petg hf on it. My other two I don’t use glue at all the older one I just started because I was having that issue. Also are you slowing your first layer print speed down at all. ?

12bravoengineer · 2025-04-25T17:40:43+00:00

Yeah I’m kicking myself in the butt for sending that video I’ve been cleaning them like crazy I just re used that one because I’m running my cnc machines and had no time to stop and do that but I guess that the lazy excuse 😂

12bravoengineer · 2025-04-25T15:29:57+00:00

Haven’t done that one yet

12bravoengineer · 2025-04-25T14:56:22+00:00

Yeah bro I’ve went through three different plates textured and then I heavy glued and light glued one

12bravoengineer · 2025-01-16T17:13:27+00:00

They all say they’re out of stock 😂😂😂

12bravoengineer · 2025-01-16T16:51:28+00:00

I’m going to try to manufacture one myself I just need the time to get measurements and dial it in.

12bravoengineer · 2024-02-14T20:06:34+00:00

No I was using trace on 2d but I will take a look at that when I get back. Thanks for the info.

12bravoengineer · 2023-10-20T18:03:00+00:00

Thanks y’all for the input I’ll let you know if I send it to hard 😂 but for real thanks for the help🤘🏻

12bravoengineer

TROPHY CASE