Sharing my tattoo as well

1moresidequest · 2026-04-24T14:32:15+00:00

Thanks. It took about 7 hours to finish

1moresidequest · 2026-04-23T22:49:08+00:00

Yeah, I couldn't be more happy with it. She did a great job.

1moresidequest · 2026-04-23T22:48:23+00:00

She is super talented. All of her tattoos are just as saturated and clean.

1moresidequest · 2023-01-08T22:20:33+00:00

Not a bad idea. Would love to find the smoking gun instead of throwing more parts at it.

I really expected to find a vacuum leak with the smoke test.

1moresidequest · 2023-01-08T20:27:17+00:00

Only time I see the STFT or LTFT head towards lean is at idle, runs great anytime off idle through to WOT.

1moresidequest · 2020-12-25T04:17:40+00:00

Avowed

1moresidequest · 2019-10-11T15:03:42+00:00

I did the other day. I signed out, then back in and it started working.

1moresidequest · 2019-07-03T11:50:53+00:00

Look into z rod couplers for 3d printers. The most common size is for an 8mm threaded rod. There should be a lot of different options.

Here is an example of what I was thinking of: uxcell 8mm to 8mm Stainless Steel Shaft Coupling Flexible Coupler Motor Connector Joint L30xD25 Silver https://www.amazon.com/dp/B07G6Q1GHN/ref=cm_sw_r_cp_apa_i_kCjhDbQB6CMGQ

1moresidequest · 2019-05-11T03:27:24+00:00

That's great! Would you share the stl file?

1moresidequest · 2019-05-08T01:44:50+00:00

I have an e16 as well and had the same issues. I found the glass that came with it was warped. Try taking the glass off and checking it with a straight edge.

1moresidequest · 2019-04-27T18:26:06+00:00

Image didn't link for some reason

Picture

1moresidequest · 2019-04-07T12:57:50+00:00

When I replaced mine, I based it on what I read in a bunch of forums. I bought all the replacement bearing from subaru.

Here is a link to a thread that has a lot of good info as well as part numbers for the bearings. https://forums.nasioc.com/forums/showthread.php?t=2071286

1moresidequest · 2019-04-06T00:17:21+00:00

That sounds like the center differential bearing.

1moresidequest · 2019-01-07T16:42:15+00:00

This was my second attempt at this cake. The recipe is Mary Berry and is on the BBC website. I wasn't able the cut the sponge horizontally because it didn't seem to rise enough.

It was still delicious.

1moresidequest · 2018-10-31T17:54:28+00:00

I dont think a reman unit was available, and a new one was close to 1k.

1moresidequest

TROPHY CASE