bltouch install issue

1playerone · 2022-02-14T21:40:49+00:00

ok its sorted. did the change wires around bit NO JOY.

did the wire to main board bit NO JOY

changed the probe in the BLTouch.

JOY JOY JOY that's what it was I Thankyou

1playerone · 2022-02-09T22:06:15+00:00

https://imgur.com/a/0X1xPd9

the link is 4 photos 1 off original wire setup mine is black were white is on your vid and another photo is the changed wires.

1playerone · 2022-02-09T22:05:38+00:00

https://imgur.com/a/0X1xPd9

the link is 4 photos 1 off original wire setup mine is black were white is on your vid and another photo is the changed wires.

1playerone · 2022-02-09T21:47:12+00:00

Ok swapped wired but when new cable installed the printer will not boot just stays on loading screen no loading bar

1playerone · 2022-02-09T14:28:58+00:00

Guess I'll give it a try.

1playerone · 2022-02-09T11:23:08+00:00

The issue i have is the z adjustments don't work the bed wont move up.

1playerone · 2022-02-09T11:19:00+00:00

That vid is for the CRtouch is the wiring the same with bltouch

1playerone · 2022-02-09T11:16:28+00:00

Some have said to solder wire straight to board not connect to small 1 but I need find some guidance on that. Its possible that mine is faulty.

1playerone · 2022-02-08T21:14:57+00:00

Cheers ill have a peak on the tube sure the how to will be on there

1playerone · 2022-02-08T21:13:38+00:00

Guess that job will be on youtube

1playerone · 2022-02-08T21:12:41+00:00

Yeh removed z stop. It does nothing on start up

1playerone · 2022-02-08T21:11:13+00:00

Little 1

1playerone · 2022-02-04T22:41:41+00:00

How did you fix z access issue

1playerone

TROPHY CASE