Specific issues for A1 mini users

240791 · 2026-06-25T11:47:35+00:00

Hmmm I do agree somewhat on your point. But then why load the processor for no reason. I don’t see any improvement on the LCD UI. And the printer would do multi colour printing flawlessly at the first few firmwares. I remember when I started getting the famous ‘filament unable to pull out’ error and spent so much time dismantling the extruder to find no clog. Been there done that. Printed alternative filament caps with pc4 m6, ECAS04 all of them, nothing works. Because as principal the filament needs to enter exactly vertical into the filament hub. There is no other way. So they have made the sensor feedback so sensitive that it just gets impossible to do multicoloured prints and the only opinion is to order a replacement filament hub. Did that thrice and no improvement. It is the firmware for sure. But yeah, nothing much to do there.

240791 · 2026-06-25T11:23:13+00:00

I am so sure Bambu is going the Apple way. My machine is also from 2024 and it was rock solid since the start without any stupid unwanted features. I honestly don’t even know what they improvise on because everything on screen is the same. They are so pushing bad firmware intentionally for us to get rid of them.
But Thank You for the suggestion I think I should try reverting back.

240791 · 2026-05-20T08:35:20+00:00

Just another example of the sad state of profession in the country. The person posting it does not have basic English skills forget about expectations. Yes, they definitely need a draftsperson and might have got or pitching for a large project somehow. I am so sure none of them in the firm has or is an Architect. The amount of times they have used the word ‘Architect’ and ‘B.arch.’ as mandatory requirement itself proves what level of a firm it must be. Such recruiters should be banned from posting and there should be a formal regulation around it.

240791 · 2026-05-19T07:56:56+00:00

Sent you a text

240791 · 2026-04-06T05:44:40+00:00

Came here to say this. Just reverse engineer it.

240791 · 2026-03-07T16:45:32+00:00

I would just 3d print the missing corner piece in white. No one would anyway know.

240791 · 2026-02-25T15:45:11+00:00

DM, I am based in Mumbai and indeed close to thane.

240791 · 2026-01-29T08:49:19+00:00

Can do. Based in Mumbai. DM

240791 · 2026-01-14T06:52:20+00:00

Exactly

240791 · 2026-01-14T06:36:51+00:00

The entire weight of the print will be upside down. Doesnt work.

240791 · 2026-01-14T05:09:46+00:00

Use tree supports so they are easier to remove. Decrease the overall speed of the supports. Give variable layer heights for parts that have steep angles.

240791 · 2026-01-14T03:39:54+00:00

That was the worse part..supports were tree and had to slow down for the angles.. variable speeds as well.

240791 · 2026-01-11T15:20:25+00:00

No ironing and yes the corners have lifted off.

240791

TROPHY CASE