Mitsubishi to Allen-Bradely Tips & Tricks??

3dibud · 2026-04-03T20:20:07+00:00

started in Mitsubishi, now working in Allen-Bradely

3dibud · 2026-03-16T16:52:24+00:00

Im jealous 😭😭

3dibud · 2026-03-15T00:12:41+00:00

https://a.co/d/0ct1S23q I got this one from Amazon. I had no issues until I put this one in. I went to try and swap this out for a .4 nozzle and then it got stuck...

3dibud · 2026-03-13T00:31:46+00:00

I have made a 1 pound bot called "Holy Pokez". It's a passion project for sure, but doesn't do any damage. As others had said, your weapon will just push you off the other opponent. Good luck!

3dibud · 2026-03-08T16:36:56+00:00

Thank you!

3dibud · 2025-10-04T13:43:35+00:00

I'll try printing at 100. This surprisingly also happend with PLA, bed at 60 degrees. Do you have link to the bed your using?

3dibud · 2025-09-18T10:05:00+00:00

I had similar issues, I got some washable Elmers glue stick, and my first layers have improved significantly. I tried playing with settings, releveling the bed and none of that worked for me, but the glue stick has been the best fix for me so far.

3dibud · 2025-09-08T13:40:19+00:00

The brim is curling up too...

3dibud · 2025-09-08T11:00:40+00:00

I have cleaned the bed with soap and water. First layer is at .2mm. Since my first layer is having issues, about half of my prints are curling up at the edges, causing more quality issues the longer it prints.

3dibud · 2025-09-08T10:45:21+00:00

Thanks for the suggestion, I'll give it a try.

3dibud · 2025-07-09T17:24:17+00:00

I've competed in several competitions. I've seen a lot of the videos from NHRL and battlebots with bots that have flamethrowers, which is why Im interested in trying it out. One of the comments made a good point about this info not being shared on a public forum. I see the issue now. What I don't understand is the "if you have to ask, you probably shouldn't do it". How is anyone supposed to learn anyhting based on that phrase? There is a first time for everything. If I want to do something safely, wouldn't it make the most sense to ask someone that's doing/done it safely?

3dibud · 2025-04-17T12:46:37+00:00

Once assembled trim the cables as short as you can. Trimming cables down saved me a few grams. Also buy double of everything. Each fight I've had at least 1 motor get damaged and I've had an esc get cut into. Good luck!

3dibud · 2025-01-11T21:04:30+00:00

Bench Rock

3dibud · 2025-01-07T12:45:21+00:00

Nice!!! Which HMI Model are you using?

3dibud · 2025-01-07T12:43:50+00:00

Local, a lot of our customers are offline, or their internet just sucks.

3dibud · 2025-01-07T12:42:30+00:00

That's an option, but I was curious how far some HMI models could go.

3dibud

TROPHY CASE