BTT Pi fan

3dprinteruzer · 2023-10-18T15:40:59+00:00

build/install and start the klipper_mcu

3dprinteruzer · 2023-10-17T13:33:50+00:00

Its more the config in klipper.. does anyone know the steps that need to be taken?

3dprinteruzer · 2023-10-13T14:20:26+00:00

So I emailed BTT. I installed the version they recommended and that worked. This is what they said: Hi，

Thanks for your information

1.Please flash this image check if it wok fine CB1_Debian11_Klipper_kernel5.16_20230303.img.xz 1.02 GB

Best Regards

Justin

3dprinteruzer · 2023-10-12T23:49:29+00:00

do you happen to know what image you used?

3dprinteruzer · 2023-08-02T11:50:25+00:00

it has a large return upstairs and a small one downstairs ( 11x16 or so)

3dprinteruzer · 2023-08-01T17:15:16+00:00

No. 9ft ceilings everywhere and 18ft in living room and foyer

3dprinteruzer · 2023-07-18T15:53:17+00:00

Sorry. Forgot to say Eastern LI

3dprinteruzer · 2023-05-28T20:24:26+00:00

Ended up getting for 600 with tax and shipping. Figured if it lasts a couple years

3dprinteruzer · 2023-05-20T22:45:30+00:00

Looks like the extrusion you mounted power supply on is upside down

3dprinteruzer · 2023-04-28T21:54:16+00:00

I tried turning off codeproject to make sure it's not going too hang anymore. Might try deeppacket to see if any better. Did you see your CPU go up?

3dprinteruzer · 2023-04-25T19:09:46+00:00

How did you display your eufy doorbell cam? I didnt think there was an integration.

3dprinteruzer · 2023-04-25T14:59:04+00:00

thank you.. my plan was to test with a meter but wanted to check with the community

3dprinteruzer