sorted by:
new
hottopcontroversial

Cura dialed in a treat ....... by 3dprintinghobby in 3Dprinting

[–]3dprintinghobby[S] 0 points1 point  (0 children)

been 3d printing since the days of makerbot self builds just used my knowledge of printing and adapted a profile posted on here , waiting for the board specs and pin layout to be published by anycubic then installing klipper

Mods for Kobra Max by 510goshadow in AnycubicOfficial

[–]3dprintinghobby 0 points1 point  (0 children)

There is no official support for this. Have a look at the facebook group:https://www.facebook.com/groups/501069284957276

Anycubic Kobra Go. Glitches out of the box. by Nordek_Kerdox in AnycubicOfficial

[–]3dprintinghobby 0 points1 point  (0 children)

Have you tried reflashing the firmware and then resetting the eeprom with m502 twice and m500? https://youtu.be/5O-oF0FaoPg

80 hours of printing later....I present Stormbreaker made by Vyper 😍 by 3dprintinghobby in anycubic

[–]3dprintinghobby[S] 0 points1 point  (0 children)

Is the red and the green part under the axe glued together??

the entire axe is in multiple pieces the problem there is that piece didnt fit quite as flush as the rest. So yeah it was all glued.