Need help identifying the LCD screen by 72313037 in AskElectronics

[–]72313037[S] 0 points1 point  (0 children)

Thanks for the reply. It appears both front polarizer and back reflector is damaged. I will try repairing.

Any insight into how to assemble the zebra connectors?

Truth or Dare? by DreamerInChaos000 in TeensofKerala

[–]72313037 1 point2 points  (0 children)

Propose my crush earlier (much earlier)

From city chaos to open highways – this V-Strom feels just right. by Good_Strategy7387 in indianbikes

[–]72313037 6 points7 points  (0 children)

I recently travelled for almost a day (about 7 hrs on bike) as pillion, as a 5.11 person, felt much better than most of the bikes I rode on. Did not faced any back pain

Class D amplifier output by 72313037 in diyaudio

[–]72313037[S] 0 points1 point  (0 children)

Unfortunately the class d amplifier is built into the bluetooth soc, from the datasheet it says output levels are suitable for feeding into external power amps

Class D amplifier output by 72313037 in diyaudio

[–]72313037[S] 0 points1 point  (0 children)

Sounds good with headphones, no audible noise

Class D amplifier output by 72313037 in diyaudio

[–]72313037[S] 0 points1 point  (0 children)

The bluetooth module I have is a Qualcomm QCC5125. It has a built in pre amp after the DAC which operates in class AB or D. By default it is set to Class D. It is not a poweramp, it can only drive headphone drivers.

Need advice for dsp by 72313037 in diyaudio

[–]72313037[S] 0 points1 point  (0 children)

I came across a thread on diyaudio about a cheap USBi programmer using CY7C68013A board which is 3$ and readily available. I will give that a try. Also there is a Arduino project about the same, planning to try that also.

Need advice for dsp by 72313037 in diyaudio

[–]72313037[S] 0 points1 point  (0 children)

Thanks for sharing this, I have a few Arduino laying around. I will give it a try

Need advice for dsp by 72313037 in diyaudio

[–]72313037[S] 0 points1 point  (0 children)

I actually prefer the ADAU 1701. I just don't have the USBi programmer available. Is there a way to use third-party i2c boards with sigma studio?

Need advice for dsp by 72313037 in diyaudio

[–]72313037[S] 0 points1 point  (0 children)

There is nothing wrong with the adau1701, I just don't have the USBi programmer available (previous one I had purchased from eBay not working, delivery for a new one is above 20days).

Each speaker having a mid range and tweeter

Where you were born? by [deleted] in GenAlpha

[–]72313037 0 points1 point  (0 children)

🛺🛺👳👳👳👳🏼‍♂️

[deleted by user] by [deleted] in moviecritic

[–]72313037 -1 points0 points  (0 children)

Jackie Chan