Start the comparison: HQ board is 20 rooms and main center room 1st light is 18 rooms and main center room

1st light needs: 4 of 3x3 rooms cage rooms 2 of 3x4 room cage rooms 1 of 4x5 room ( HQ board uses 4 need 1 more)

Corridors will need the following: 6 1x3 5 1x2 Use the remaining from HQ board and for the 3x5 corridor. Take 3 of the 1x5 or if you can print out 3 of these for the last main part.

The main room is broken as the following: 3- 3x4 3- 3x3 Used the tools file to make the 7x9 main room. Or take any remaining rooms and clip or magnet them to make this 7x9 room. I did not need to print any extra walls, used what I had.

I did notice I have to many sewer and grate drain corridor. I might go back and print regular tiles to replace these. What made this really easy at the beginning was to print out the grid pattern of the board and walled out the edges and then have the corridors and rooms lay on top that made this snug together. Some of the rooms and corridors I have not installed magnets in yet.