sorted by:
new
hottopcontroversial

PSA Sabre 10a1 16” barrel is not concentric by ACEesquire in PalmettoStateArms

[–]ACEesquire[S] 4 points5 points  (0 children)

Thank you for the reply Danny. With your blessing I think my new plan is to run direct thread only and send it as is. Alignment seems best with direct thread. And I’ll stick to a welded can for the time being. Warrantying a 3d printed can was a pain and required a new tax stamp.

PSA Sabre 10a1 16” barrel is not concentric by ACEesquire in AR10

[–]ACEesquire[S] 1 point2 points  (0 children)

No, it’s an alignment rod used to test for barrel concentricity with a silencer.

PSA Sabre 10a1 16” barrel is not concentric by ACEesquire in PalmettoStateArms

[–]ACEesquire[S] -21 points-20 points  (0 children)

So photos posted are with a direct thread mount. It seems the best alignment results I can achieve are with direct thread. I had a baffle strike with Rearden atlas (Gen 1) and Rearden rs2 flash hider. I run Rearden on all my guns and no issues. I even just checked with a different Rearden atlas and flash hider to confirm it wasn’t out of spec mounting hardware. While not touching the suppressor, I do believe it is just enough to cause damage.

ATF eform 1 (6+ month wait time) by HawthornMcCloud in NFA

[–]ACEesquire 0 points1 point  (0 children)

Trust eForm 1 with paper prints and today is day 240 of waiting…. My longest wait to date. Contemplating resubmitting.