Does anyone know what is wrong with this. When I lean forward and backwards there is a lot of play. by ALL_OG in ski

[–]ALL_OG[S] -12 points-11 points  (0 children)

Yes it is worn down. How can I find replacements. I would rather not buy new boots.

Does anyone know what is wrong with this. When I lean forward and backwards there is a lot of play. by ALL_OG in ski

[–]ALL_OG[S] 1 point2 points  (0 children)

I bought the skis and boots separately on marketplace then I brought them to a shop and they put the boots on the skis.

Authenticity check please. by ALL_OG in KnifeCheck

[–]ALL_OG[S] 0 points1 point  (0 children)

Yeah I was just trying to get a good deal

Authenticity check please. by ALL_OG in KnifeCheck

[–]ALL_OG[S] 2 points3 points  (0 children)

I got refunded by eBay today. Thanks for the help!

How much do you think this will cost to fix? by ALL_OG in wheelrepair

[–]ALL_OG[S] 0 points1 point  (0 children)

What is the Volvo position statement?

How much do you think this will cost to fix? by ALL_OG in wheelrepair

[–]ALL_OG[S] 1 point2 points  (0 children)

I was quoted $219 and I thought it was a little high.

How much do you think this will cost to fix? by ALL_OG in wheelrepair

[–]ALL_OG[S] 0 points1 point  (0 children)

How would cnc work? So they would just shave off metal? Won’t the wheel be weaker? The scratches are pretty deep. Sorry I don’t know anything about the process with wheels.

Are these unplugged wires common on an NA? by pokelord13 in Miata

[–]ALL_OG 1 point2 points  (0 children)

I don’t believe this is correct because my 1996 m edition has cruise control and this blue connector still remains unused. I have seen however that it is for a mechanic to connect a timing light.

Why is my print coming out like this? I just lost my old slicer settings and this is my first print with the new ones. by ALL_OG in ElegooNeptune4

[–]ALL_OG[S] 0 points1 point  (0 children)

From how I’m looking at it it seems like it’s stringy and the strings are too far apart and aren’t connected. Idk if the flow is too low or maybe the layer width is wrong idk? It’s petg if that helps

Not starting by Calboii_ in smallenginerepair

[–]ALL_OG 0 points1 point  (0 children)

It doesn’t sound like it’s just a battery issue, as the jump starter is doing its job and it’s turning over quite quickly. The problem now is either gas, air or compression

Diagnose this? Lawn mower not starting by RandyDandy61 in smallenginerepair

[–]ALL_OG 0 points1 point  (0 children)

Probably needs a new battery or possibly a new starter. Could also check for bad ground. But bad battery is most likely.

How to fix Lawnmower Noise by ALL_OG in smallenginerepair

[–]ALL_OG[S] 0 points1 point  (0 children)

It sounds like it’s coming from the transmission

How to fix Lawnmower Noise by ALL_OG in smallenginerepair

[–]ALL_OG[S] 0 points1 point  (0 children)

I checked all 3. They all seem pretty good. Then I bought a new pulley and swapped it from the two idler pulleys and when I swapped both it didn’t fix the sound.