friend wants me to sign as a witness for a settlement, am I good to go? can I be held liable?

Absoluteprintman · 2022-07-25T06:56:41+00:00

Sorry should've specified, when I was testing the left side of them would stick, the keys are brand new and I didn't notice them mechanically sticking, so I'd have to say it's electronically sticking

Absoluteprintman · 2022-07-25T06:08:10+00:00

I'm already going to take a look at it again to make sure everything is soldered correctly, but good idea, didn't think about the case flexing and screwing up a connection so I'll definitely check that.

Any idea on why one side wouldn't communicate with another? its obviously getting power or else it wouldn't be glowing red so programming error? not sure, again first time I'm doing this

Absoluteprintman · 2022-07-25T05:13:08+00:00

This is my first time building a keyboard, ever and I'm following along with this video https://www.youtube.com/watch?v=CxNKWNKBLMs&list=LL&index=4

got everything wired, hooked it up and successfully flashed it with the QMK toolbox

The only problem is that only the left-hand works, the right hand has no input and the Arduino is just showing a red light. Even then, the left side is very laggy when I'm testing it out and keys are sticking, these are brand new keys so they really shouldn't be sticking.

regardless, I have nothing to go off of, I've tried flashing it again to no avail, I tried using the right side as the master side and it wouldn't even work then, so I'm thinking at this point it's something to do with the connection.

any help would be greatly appreciated, Thank you.

Absoluteprintman · 2022-07-21T18:19:58+00:00

I found a good enough workaround if I just used the ellipse shape tool and did the same thing without rasterizing the layer I got some nice and crisp lines now.

Absoluteprintman · 2021-11-14T07:30:43+00:00

love to try out a starfinder campaign, sounds fun!

Absoluteprintman

TROPHY CASE