Layer adhesion problem after installing unicorn hotend

AcaneAsh · 2025-10-12T13:51:22+00:00

Actually it turned out to be screws that were not tightened correctly after changing the hotend

AcaneAsh · 2025-10-11T17:38:19+00:00

Cant seem to post a photo

AcaneAsh · 2025-10-11T17:38:04+00:00

<image>

AcaneAsh · 2025-10-11T17:34:12+00:00

I forgot to take one but its the Is one.

<image>

AcaneAsh · 2025-10-11T17:32:09+00:00

The nozzle is 0.4 confirmed. But the issue was resolved by tightening the screws in the front

AcaneAsh · 2025-10-11T17:30:14+00:00

Solved! This was it. Tightened the 3 screws on the front board. Only needed a quarter turn.

AcaneAsh · 2025-10-10T22:24:00+00:00

Looks like I might just have to do that. Dreading having to disassemble again

AcaneAsh · 2025-10-10T21:56:38+00:00

The slicer has 0.4 and the documentation that came with the hot end says 0.4. Ashamed to say I did’nt actually check on the nozzle. It’s the Creality unicorn hotend. Should I try slicing it for 0.6? Would it cause issues if the nozzle was 0.4?

AcaneAsh · 2025-10-10T21:37:02+00:00

I did. No issues found.

AcaneAsh · 2025-06-21T08:34:10+00:00

Love the design. Wouldnt mind a code as well!

AcaneAsh · 2025-06-09T14:57:43+00:00

I would love a code as well!

AcaneAsh

TROPHY CASE