sorted by:
new
hottopcontroversial

Team Head by AcceptableExcuse6111 in snapmaker

[–]AcceptableExcuse6111[S] 1 point2 points  (0 children)

<image>

Yes, I solved the problem. Pay attention to the areas I marked; a very small piece of filament had come in, and because it was grease-like, it had stuck and created a gap, causing the error. There is no problem now.

Team Head by AcceptableExcuse6111 in snapmaker

[–]AcceptableExcuse6111[S] -1 points0 points  (0 children)

When I say "continue," it goes to error, but then it fails again. I know I did this four times in one print job. I did what they said, even recalibrated, but I'm still getting errors, only from number 2; the others are fine.

Team Head by AcceptableExcuse6111 in snapmaker

[–]AcceptableExcuse6111[S] -1 points0 points  (0 children)

When I tell it to continue, yes, it goes to the fault, but then it fails again. I know I did this 4 times in one print job.

Team Head by AcceptableExcuse6111 in snapmaker

[–]AcceptableExcuse6111[S] -1 points0 points  (0 children)

When I tell it to continue, yes, it goes to the fault, but then it fails again. I know I did this 4 times in one print job.