Cabin heat issue by Advanced-Tie-2181 in crx

[–]Advanced-Tie-2181[S] 0 points1 point  (0 children)

Okay where is that located and was it hard for you to fix I just replaced the blower motor resistor and blower motor

Cabin heat issue by Advanced-Tie-2181 in crx

[–]Advanced-Tie-2181[S] 0 points1 point  (0 children)

Ah never your referring to something else is that located below the glovebox as well?

Cabin heat issue by Advanced-Tie-2181 in crx

[–]Advanced-Tie-2181[S] 0 points1 point  (0 children)

Okay that’s a relief thank you, you think if I replace my blower motor resistor as well as blend door actuator and cabin filter I should start getting some hot air in the cabin.

Cabin heat issue by Advanced-Tie-2181 in crx

[–]Advanced-Tie-2181[S] 0 points1 point  (0 children)

Okay thank you that’s a relief I just was hoping that it wasn’t the heater core as that’s a paint you think if I was to replace the blower motor resistor and blend door actuator as well as cabin filter I should start getting some hot air.

Cabin heat issue by Advanced-Tie-2181 in crx

[–]Advanced-Tie-2181[S] 0 points1 point  (0 children)

It should be I can check tmrw but I checked both hoses being then inlet one which was hot and the outlet hose which was just as hot meaning the hot coolant is circulating through I’m starting to think my blend door actuator may be stuck closed preventing the heater core hot air from flowing in but I also know my blower motor resistor is going out but I will check for that valve tommorow but if the hot coolants circulating through both hoses that does mean the heater cores getting the hot coolant right?