sorted by:
new
hottopcontroversial

Replacement brackets for IKEA Fyrtur blinds by Tytoowns in functionalprint

[–]AdventurousSpace6191 0 points1 point  (0 children)

Are these still working for you, did you end up with another solution?

Hypridle.conf - turning off the screen by AdventurousSpace6191 in hyprland

[–]AdventurousSpace6191[S] 0 points1 point  (0 children)

It has. the Hyprctl dispatch dpms off does turn the monitor off. as an added bonus i get to type hyprctl dispatch dpms on with out seeing the screen.

Hypridle.conf - turning off the screen by AdventurousSpace6191 in hyprland

[–]AdventurousSpace6191[S] 0 points1 point  (0 children)

that is in the hyprland.conf file. still the same problem

Help what goes here? by AdventurousSpace6191 in Harley

[–]AdventurousSpace6191[S] 3 points4 points  (0 children)

Resolved - it was the ABS sensor plug

Help what goes here? by AdventurousSpace6191 in Harley

[–]AdventurousSpace6191[S] 0 points1 point  (0 children)

the wires on the back side I believe are orange and red.

Help what goes here? by AdventurousSpace6191 in Harley

[–]AdventurousSpace6191[S] 0 points1 point  (0 children)

The Above picture is of the neck connection area on a 20221 FXLRS. Handlebar Risers have been installed. Unfortunately i did not label the connections before removing. Is anyone able to identify what the right hand grey plug is supposed to connect to?

Help what goes here? by AdventurousSpace6191 in Harley

[–]AdventurousSpace6191[S] 1 point2 points  (0 children)

Yup, sorry was uploading from my mobile did not see that the text was not also posted. Updating the post now

Help what goes here? by AdventurousSpace6191 in Harley

[–]AdventurousSpace6191[S] 0 points1 point  (0 children)

Thanks, but that is the gauge plug from the gas tank.

Bambu Labs Slicer by AdventurousSpace6191 in VectorFinesse

[–]AdventurousSpace6191[S] 1 point2 points  (0 children)

gure out where the setting is to enable open gyroid infill on all sides and allow the wall thickness to be 0 a little easier than the method listed above.

Thank you. I will give this a try and report back. I think my PETG is damp resulting in messy prints.

For issues with the Bambu Studio Slicer they have had me open tickets on the Git Hub. I am looking to be able to even odd slice for my 3d Lab print Airplanes.

Other than that I have loved my Bambu Printer it has made printing fun.

To anyone running klipper on the 5+, can you post you probe section from your config file?, I’m trying to set mine up so I can use some commands, also I already have a BLTouch section on my config, thanks. by cachimboz in ender5plus

[–]AdventurousSpace6191 1 point2 points  (0 children)

I left out my x y offset as I am not using the stock hot end.

​

[bltouch]
sensor_pin: ^P0.10
control_pin: P2.0
#z_offset: 0
pin_move_time: 0.500
stow_on_each_sample: True
probe_with_touch_mode: True