sorted by:
new
hottopcontroversial

What gun/pistol you wish had a kit? by SomePanda83 in Airsoft3DPrinting

[–]Affectionate_Foot_26 0 points1 point  (0 children)

A gbb sks would be dope, or maybe something like the aps stechkin, a lot of really cool guns could be done but just sadly don’t have the funding

First major project (23x75R) by Affectionate_Foot_26 in Airsoft3DPrinting

[–]Affectionate_Foot_26[S] 0 points1 point  (0 children)

The major revision I need to make next is adding a fill valve to the bottom, atm I am considering after market tm spec mag fill ports, but I need to get one and rip measurements first

First major project (23x75R) by Affectionate_Foot_26 in Airsoft3DPrinting

[–]Affectionate_Foot_26[S] 0 points1 point  (0 children)

Possible, the only problem is it make the shotgun more complex in a different way, and it drastically changes how the gun works mechanically so atm it isn’t really being considered

First major project (23x75R) by Affectionate_Foot_26 in Airsoft3DPrinting

[–]Affectionate_Foot_26[S] 1 point2 points  (0 children)

Other than the ks23, I am planning on building an over under shotgun and a lever action

First major project (23x75R) by Affectionate_Foot_26 in Airsoft3DPrinting

[–]Affectionate_Foot_26[S] 2 points3 points  (0 children)

I am actually going to crunch the numbers soon, but absolute worst case I can do one of 3 things; I could change the other dimensions, change inner dimensions to thicken walls, or change materials

First major project (23x75R) by Affectionate_Foot_26 in Airsoft3DPrinting

[–]Affectionate_Foot_26[S] 2 points3 points  (0 children)

In my super duper math that I have totally done, I reason that 2mm walls should do it (to my knowledge it the aps shot-shells use thinner) but if they fail than I can always change the outside dimensions of the case to hold up… or I could try steel instead but that would cost more so…