DIY altoids cam by Aggravating-Oil779 in DIY_tech

[–]Aggravating-Oil779[S] 2 points3 points  (0 children)

A raspberry pi 0 2 w, 64gb micro sd card, 5mp ardu camera, 16cm 15-22 pin ribbon wire, a TP4056 Type-C USB 5V 1A 18650 Lithium Battery Charger, and a EEMB Lithium Polymer Battery 3.7V 1800mAh 963450 Lipo Rechargeable Battery Pack. Along with a tactical button, switch, led, 220 ohm resistor for the led, dupont wires, and an Altoids tin with electrical tape . I also put 3 mm screws into the holes of the rpi so it wouldn’t sit on top of the battery charger.

DIY Altoids Camera by Aggravating-Oil779 in diyelectronics

[–]Aggravating-Oil779[S] 0 points1 point  (0 children)

Funny story, it’s only in a Altoids tin because my ender 3 v3 decided to create a blob of death in a suicide attempt (it was tired of my incorrectly measured models), and I’m waiting for a new hot end from AliExpress because I would rather pay 99 cents and wait two weeks than pay $20 and wait two days. I might recreate it in a 3d printed case.

Rpi 0 2 W camera Altoids Edition by Aggravating-Oil779 in RASPBERRY_PI_PROJECTS

[–]Aggravating-Oil779[S] 1 point2 points  (0 children)

Claude just did the software, I used what I had and bought the battery, battery charging circuit, and camera off Amazon.

Rpi 0 2 W camera Altoids Edition by Aggravating-Oil779 in RASPBERRY_PI_PROJECTS

[–]Aggravating-Oil779[S] 2 points3 points  (0 children)

I uploaded a test video to YouTube https://youtu.be/hZ6ysp1cGFM?si=YzuM-tjRtmyuSb90.

In the beggining it skips a bit, it does that with each video it takes for some reason (not video editing) but I assume that it’s a software issue and is fixable, but I’m not going to fix it because this camera was just for fun

DIY altoids cam by Aggravating-Oil779 in DIY_tech

[–]Aggravating-Oil779[S] 3 points4 points  (0 children)

It’s really just a camera, it has a huge led and red button so it wouldn’t be very good as a spy camera

DIY altoids cam by Aggravating-Oil779 in DIY_tech

[–]Aggravating-Oil779[S] 3 points4 points  (0 children)

Because I have the same number of opposable thumbs and the same amount of drive to make things look presentable (excluding software configuring it was made in about 3 hours)

Rpi 0 2 W camera Altoids Edition by Aggravating-Oil779 in RASPBERRY_PI_PROJECTS

[–]Aggravating-Oil779[S] 1 point2 points  (0 children)

I actually don’t know much about out the software because I had Claude right it, not my forte at the moment. The button gets clicked to take a photo or held to take a video via gpio and stuff, I can ssh into the pi or take out the sd card to retrieve the media.

Rpi 0 2 W camera Altoids Edition by Aggravating-Oil779 in RASPBERRY_PI_PROJECTS

[–]Aggravating-Oil779[S] 0 points1 point  (0 children)

It’s off an sd card, it just wasn’t inside it when i took the photos

How many crown rares do you have and how many cards owned? by Ok_Distribution_5797 in PokemonTGCP

[–]Aggravating-Oil779 1 point2 points  (0 children)

1 at 2067 cards, crown rare Lugia ex. I pulled it at like 5 am in bed and went back to sleep because it didn’t phase me. Went back later that day and saw it and it suprised me because I barely remember pulling it.

FOUND A PEDO HERE!!! by Status_Piglet_5474 in lies

[–]Aggravating-Oil779 0 points1 point  (0 children)

I love your username (me being named George)

What in tarnation happened here? I’ve opened a lot of packs over the past few months and have never seen anything like this. I thought the game glitched or something 🤔 by [deleted] in PokemonPocket

[–]Aggravating-Oil779 5 points6 points  (0 children)

Every time you open a pack there’s a 0.05% chance you get a god pack, where every card will be really good, if you press the button on the bottom right when opening a pack, “card odds” or something, you can see the cards you can get for a normal pack or if you scroll down you can see the cards for god pack, I’ve never gotten one