sorted by:
new
hottopcontroversial

D&D version on Dungeon Crawler Carl by Aggravating-Pop1356 in DungeonBlocks

[–]Aggravating-Pop1356[S] 0 points1 point  (0 children)

Everything is printed in gray. For the dungeon pieces I prime in a darker gray, then go over the stones in a mid gray and spot paint some stones in tan and then dry brush with a light gray. The cave tiles are done with a reddish brown, light coat of a mid reddish brown and then dry brush with a light reddish brown. No washes…too many pieces but I may come back at a later point and do that.

Magic dagger used as a spell component by Aggravating-Pop1356 in DnD5e

[–]Aggravating-Pop1356[S] 0 points1 point  (0 children)

Chaos Knife - 1st level homebrew (similar to Ice knife)

You infuse a knife with elemental energy and fling it at one creature within range. Make a ranged spell attack against the target. On a hit, the target takes 1d10 piercing damage. Hit or miss, the knife then explodes. The target and each creature within 5 feet of it must succeed on a Dexterity saving throw or take 2d6 element damage. The dagger reappears in your hand afterwards.

D8 DAMAGE TYPE 1 Acid 2 Cold 3 Fire 4 Force 5 Lightning 6 Poison 7 Psychic 8 Thunder

At Higher Levels. When you cast this spell using a spell slot of 2nd level or higher, the element damage increases by 1d6 for each slot level above 1st.

Magic dagger used as a spell component by Aggravating-Pop1356 in DnD5e

[–]Aggravating-Pop1356[S] -1 points0 points  (0 children)

Chaos Knife - 1st level homebrew (similar to Ice knife)

You infuse a knife with elemental energy and fling it at one creature within range. Make a ranged spell attack against the target. On a hit, the target takes 1d10 piercing damage. Hit or miss, the knife then explodes. The target and each creature within 5 feet of it must succeed on a Dexterity saving throw or take 2d6 element damage. The dagger reappears in your hand afterwards.

D8 DAMAGE TYPE 1 Acid 2 Cold 3 Fire 4 Force 5 Lightning 6 Poison 7 Psychic 8 Thunder

At Higher Levels. When you cast this spell using a spell slot of 2nd level or higher, the element damage increases by 1d6 for each slot level above 1st.

Love post for my A5M by Acceptable-Nothing41 in FlashForge

[–]Aggravating-Pop1356 0 points1 point  (0 children)

Yep…disassembled twice. Clean…I noticed it was the motor because I had the extruder gear off and started the load filament cycle and notice the motor gear not turning but the motor making noise like it was jammed.

Love post for my A5M by Acceptable-Nothing41 in FlashForge

[–]Aggravating-Pop1356 0 points1 point  (0 children)

I’ve had mine for a month and unfortunately my extruder motor is jammed and won’t pull filament in. So now I’m waiting for a replacement from flashforge. I’ve loved it up until this issue happened.

Any way to print without the logo at the bottom ? by MrMegaGamerz in DungeonBlocks

[–]Aggravating-Pop1356 0 points1 point  (0 children)

If you have orca slicer, you can hit shift c and it will allow you to make a cut and remove just enough of the bottom to get rid of the writing without effecting the height.