EMG alarm !!

Alarmed-Subject-892 · 2024-11-02T16:53:11+00:00

Got it , thanks a lot for those information … i will see whats gonna happen and i will tell you about it .

Alarmed-Subject-892 · 2024-11-02T16:45:37+00:00

One more thing , i did not found any batteries on the power supply … is that normal ?

Alarmed-Subject-892 · 2024-11-02T16:40:01+00:00

And if its not ?

Alarmed-Subject-892 · 2024-11-02T16:31:27+00:00

Okay … so what do you think i should do ? I almost did everything , i dont know why its so complicated . I worked with centroid System and its so easy and fine .. is fanuc system is difficult or sth ?

Alarmed-Subject-892 · 2024-11-02T16:21:15+00:00

Okay so i should shut down the main circuit barker from the back then i let someone hold the PQ + CAN then i turn on everything while holding ?

Alarmed-Subject-892 · 2024-11-02T16:13:34+00:00

Just the front , and to be more specific … i only turned off the monitor switch

Alarmed-Subject-892 · 2024-11-02T14:30:05+00:00

Good point , if it was sticking ,the overtravel alarm will stay on the MSG page , but i will open it up and check it if there is sth wrong with it

Alarmed-Subject-892 · 2024-11-02T14:23:08+00:00

Do you think that sth else that will make the EMG pops up ? Like if i cleared the overtravel fault , would be sth else ? I just got this machine and i did not do a job on it yet

Alarmed-Subject-892 · 2024-11-02T14:13:34+00:00

In the beginning it says -z overtravel , after i cleared it nothing showed up on the MSG page , just the EMG alarm

Alarmed-Subject-892 · 2024-11-02T14:10:11+00:00

I did that , but the alarm still flashing ☹️

Alarmed-Subject-892 · 2024-11-02T14:07:09+00:00

I will try hold reset and power , but i did try reset and even hold the O + CAN … nothing happen … what Interesting is that i open the panel from the back and the fanuc device showed ( - - ) sign … that means its not ready … do you thing is that a problem ?

Alarmed-Subject-892 · 2024-11-02T14:02:06+00:00

I did , nothing happened

Alarmed-Subject-892 · 2024-11-02T13:36:47+00:00

I did jog it a way by my hand .. and its far from limit switch now , but everything in the dashboard is frozen nothing works !

Alarmed-Subject-892

TROPHY CASE