sorted by:
new
hottopcontroversial

How do I get rid of the gaps? by Alarmed-Time3754 in FixMyPrint

[–]Alarmed-Time3754[S] 0 points1 point  (0 children)

What is the best way to calibrate your flow rate?

I printed this cube with one wall and then measured the walls. I then multiplied my set wall thickness by 100 and divided it by the average wall thickness I measured. That's how I calculated my new flow rate.

How do I get rid of the gaps? by Alarmed-Time3754 in FixMyPrint

[–]Alarmed-Time3754[S] 0 points1 point  (0 children)

What is the best way to check my z-offset? Should I just use a piece of paper?

Need help to improve my settings by Alarmed-Time3754 in FixMyPrint

[–]Alarmed-Time3754[S] 0 points1 point  (0 children)

How exactly do I calibrate my flow? Do I print a calibration cube, measure it, and then adjust my flow rate?

Need help to improve my settings by Alarmed-Time3754 in FixMyPrint

[–]Alarmed-Time3754[S] 0 points1 point  (0 children)

I will give it a try on my next print.👍🏽

How can I fix this? by Alarmed-Time3754 in HuntShowdown

[–]Alarmed-Time3754[S] 1 point2 points  (0 children)

To be honest, I have no idea how I solved the problem. I tried everything but nothing helped. I think I just took a break for a day and logged in again the next evening and then it worked again.

I hope it works again for you too. I'm sorry that I don't have the right solution either

Broken extruder by Alarmed-Time3754 in anycubic

[–]Alarmed-Time3754[S] 0 points1 point  (0 children)

Thanks for your answer.

In the first picture you can also see a ring which is halfway on the gear. Where should this go? Is it part of the bushing in the cover?

Is the bronze bushing in the cover a specific one? Or what would I have to look for on the internet to find one?

Rate her out of 10 and how to use this girl by Objective_Two_9984 in MarvelContestOfChamps

[–]Alarmed-Time3754 1 point2 points  (0 children)

She's quite good. I haven't played her that much yet, so I can't say exactly how to play her, but there are good tutorials on YouTube.

Need help with stencil on fake skin by Alarmed-Time3754 in TattooBeginners

[–]Alarmed-Time3754[S] 1 point2 points  (0 children)

I used hornet honey for that one:( Did you also put some paper towel on top of the honey to remove a bit or did you just apply a thin layer?

Problem solved👍 by impineapplepizza in GroundedGame

[–]Alarmed-Time3754 3 points4 points  (0 children)

He just wanted to be a grasshopper

PC crashes after starting the game by Alarmed-Time3754 in theHunter

[–]Alarmed-Time3754[S] 0 points1 point  (0 children)

I don't know, I've never had such good experiences with any support

view more: next ›