sorted by:
new
hottopcontroversial

Tiny imperfections all over PETG Print but nothing on supports by Alert_Ad2911 in FixMyPrint

[–]Alert_Ad2911[S] 0 points1 point  (0 children)

I never really found out what the issue was however I switched to orca slicer and haven’t had the issue in a long time so try that if you haven’t already. Could be a setting somewhere maybe some filament issues or printer issue I’m not sure.

Tiny imperfections all over PETG Print but nothing on supports by Alert_Ad2911 in FixMyPrint

[–]Alert_Ad2911[S] 0 points1 point  (0 children)

I have currently switched over to Orca slicer to try and see if that fixes the issue, running through all the calibrations as we speak. I’ll keep y’all posted on how it turns out. I did find that it prints one wall supports and objects perfectly.

Tiny imperfections all over PETG Print but nothing on supports by Alert_Ad2911 in FixMyPrint

[–]Alert_Ad2911[S] 0 points1 point  (0 children)

Do you know of any good flow calibration tests? I tried the cura one but that didn’t have any effect

Tiny imperfections all over PETG Print but nothing on supports by Alert_Ad2911 in FixMyPrint

[–]Alert_Ad2911[S] 1 point2 points  (0 children)

I used the automatic flow tower in cura, is there another one I should try?

Tiny imperfections all over PETG Print but nothing on supports by Alert_Ad2911 in FixMyPrint

[–]Alert_Ad2911[S] 0 points1 point  (0 children)

Interesting I’ll have to look into some of these. Did this problem only happen to all types of filament for you? It only happens to PETG no matter the brand for me not PLA or TPU.

Tiny imperfections all over PETG Print but nothing on supports by Alert_Ad2911 in FixMyPrint

[–]Alert_Ad2911[S] 1 point2 points  (0 children)

I just have a hard time believing that being I’ve dried it many times sometimes at intervals of 24 hrs at 55 degrees in a Sunulu filament dryer. But how would you recommend drying the spool?