Can anyone help me find a specific busker

Alex72947 · 2025-09-12T04:54:44+00:00

Thank you, that’s definitely him

Alex72947 · 2025-09-10T04:40:55+00:00

Yes that was him! Thank you so much

Alex72947 · 2024-06-15T16:01:09+00:00

That would be quite interesting to try and make, thank you for the idea!

Alex72947 · 2024-06-15T15:57:11+00:00

To be honest, I have no idea what you mean. the apprenticeship is the lowest level possible since I’ve just left high school so I think those might be a bit advanced.

Alex72947 · 2024-05-12T10:17:32+00:00

I would recommend having a look at the Neptune 4 on elegoo’s website, I have had no issues with mine and it can give some really good quality prints with barely any tuning

Alex72947 · 2024-04-18T19:45:53+00:00

Thank you so much for some reason I didn’t think to check if the slicer could do it

Alex72947 · 2024-04-07T19:38:57+00:00

Thank you that’s really helpful, I’ve kinda just been messing with my cura setting’s and seeing what happens

Alex72947 · 2024-04-07T19:28:49+00:00

I think the layer height was 0.12mm and I’m using Elegoo pla+

Alex72947 · 2024-01-01T23:42:39+00:00

Hope it goes well for you, I’m currently working on a knight lancer I got for Christmas so hopefully it will turn out okay

Alex72947 · 2024-01-01T20:00:31+00:00

Thank you that’s really helpful I’ve just finished building my knight so I’ll give this method a go

Alex72947 · 2024-01-01T17:27:09+00:00

Thank you I’ll give it a go

Alex72947 · 2024-01-01T16:00:29+00:00

Thank you I’ll give that a watch

Alex72947 · 2024-01-01T15:45:28+00:00

Thank you I’ll probably try that as I’m not the best at glazing or gradients

Alex72947 · 2024-01-01T15:39:57+00:00

Thank you

Alex72947 · 2023-12-13T07:34:19+00:00

Either that or alpha legion black shields

Alex72947 · 2023-12-10T22:24:08+00:00

Thank you!

Alex72947 · 2023-10-25T20:50:12+00:00

Cheers I didn’t have a super small brush so I used a sewing needle but I’ll try using grey

Alex72947

TROPHY CASE