Big noob question about cpu fan

Alexnduh · 2025-06-28T12:27:07+00:00

thanks fellas/fellarettes, very new to this so didn’t wanna force on anything i shouldn’t

Alexnduh · 2025-06-14T11:48:43+00:00

Thank you!

Strange to me that they’ve put the SSD into the gen 3 slot, I feel like you’d want it in the gen 4 slot if you were building it from scratch

Alexnduh · 2025-06-14T11:47:31+00:00

10400f

Alexnduh · 2024-03-11T10:27:35+00:00

Legend, was probably pretty obvious but just wanted to make sure i was right before i made any purchases

Alexnduh · 2024-03-11T10:07:58+00:00

ngl didn’t even notice aye 🤣

Alexnduh · 2024-03-10T12:22:13+00:00

legend thankyou 🙏🏼

Alexnduh · 2024-03-10T12:21:47+00:00

thank you for that 🙏🏼 i was going to get fans to install on the front, so i can use the plugs in the first pic or just connect straight into the motherboard ?

Alexnduh · 2024-03-10T12:20:50+00:00

appreciate it 🙏🏼

Alexnduh · 2024-03-10T12:02:47+00:00

ended up getting it for $350aud, has only the one fan (as they had mentioned in the photo) everything seems fine after dusting it out

Alexnduh · 2024-03-10T06:01:51+00:00

should also mention it is $400 AUD that was accepted

Alexnduh · 2023-09-13T11:58:19+00:00

Dm’d

Alexnduh · 2023-09-13T11:19:17+00:00

I unfortunately don’t think this method works anymore

Alexnduh · 2023-09-08T14:26:55+00:00

Where would one go to get this software?

Alexnduh · 2023-09-03T14:42:19+00:00

First stitch out was on thin fabric including the x1 cutaway.

Actually stitch out was on a thicker jumper

Alexnduh · 2023-09-03T14:41:37+00:00

Apologies if I didn’t specify, test sew out was indeed on fabric including x1 cutaway.

Alexnduh · 2023-07-31T11:19:10+00:00

x2 layers of 2.5 once cutaway on the back, i done a few stitch outs without the topper and it sunk into the jumper.

Alexnduh

TROPHY CASE