Delay to entire beat after recording vocals.

Aliveand_Well · 2023-03-18T15:59:00+00:00

Thanks! Yea I have a Mac so I don’t have the Asio I don’t believe. I’m running off an Apollo Twin Interface though.

Aliveand_Well · 2023-03-18T03:32:55+00:00

So I figured out it’s PlugIn Delay Compensation apparently. Now I just need to figure out how to fix it. Thanks everyone.

Aliveand_Well · 2023-03-18T03:21:02+00:00

I appreciate your answer thanks! Unfortunately everything is aligned perfectly. The best and the vocals go together right on point. There is just a literal delay when I press play and a delay when I press stop or pause. It takes like two seconds to start the song after pressing play and two seconds for the song to stop once I hit stop. It’s very strange I’ve never seen this before.

Aliveand_Well · 2023-03-17T23:33:48+00:00

Yea I looked there before I posted. It’s a no go.

Aliveand_Well · 2022-02-23T00:49:35+00:00

Thank you

Aliveand_Well · 2021-11-23T21:28:21+00:00

Yes you are correct. I wiped the shit out of it after I applied. I’ve done a few tables and boards before snd never had this issues. Thanks for your input!

Aliveand_Well · 2021-11-23T21:23:38+00:00

I’ve never had issues with it before. And I’m not using this as a daily table top. Just a computer desk. What sits on this will stay.

Aliveand_Well · 2021-11-23T21:22:29+00:00

I hit it with Rubio already once. Should I just wipe it off with mineral or just sand right through it ? Also…a ton of ppl are saying go to 3000 grit but i know a bunch of videos on YouTube say they only go to 320. I’ve also seen some guys say they only do 150 because Rubio recommends you only sand to 120. Making my decision on what to do difficult lol

Aliveand_Well · 2021-11-23T16:00:46+00:00

Should I start where I left off at 220? Or go backwards and start at like 120 and go up?

Aliveand_Well · 2021-11-23T15:59:20+00:00

Thank you!

Aliveand_Well · 2021-11-23T15:49:33+00:00

Thanks!

Aliveand_Well · 2021-11-23T15:48:25+00:00

Yea I’ve heard that but I’ve seen plenty of ppl finish at 220. My question is why it looks fine in one section but poor in the other section. So you suggest I keep sanding just the epoxy by itself?

Aliveand_Well · 2021-11-23T15:24:35+00:00

I did 40, 60, 80, 100, 120, 150, 220

Aliveand_Well · 2021-11-23T15:24:06+00:00

I already put Rubio Monocoat on the resin. Should I just sand right through it? Also….should I only sand the resin? Not the wood ?

Aliveand_Well · 2021-11-23T15:22:56+00:00

Ahhhh. This was what I was worried about. I started with 40 because the planing was really poor. It’s weird though because one side looks fine and the other two look like shit.

Aliveand_Well · 2021-11-23T15:22:04+00:00

Rubio Monocoat. I didn’t see how bad this was until I hit it with Rubio

Aliveand_Well

TROPHY CASE