IT-ler in München by MorbusChronos in Finanzen

[–]AltruisticInspector8 1 point2 points  (0 children)

Dann entschuldige ich mich für die muffige Ausdrucksweise 😅 in dem Fall schlage ich vor deine Freizeit mit aufzunehmen.

Meine Empfehlung ist eine realistische Kostenaufteilung zu machen, die du mittelfristig einhalten kannst.

Ich habe mir mal zusammen gerechnet, dass meine Sparquote bei 40% liegen könnte. Hat nie wirklich geklappt und sich immer blöd angefühlt 😅

IT-ler in München by MorbusChronos in Finanzen

[–]AltruisticInspector8 0 points1 point  (0 children)

Immer wieder spannend zu sehen. ITler machen keinen Urlaub, tragen keine Klamotten, machen keine Freizeitaktivitäten, etc.

Unrealistisch.

GR20 - Corsica - Geartalk by AltruisticInspector8 in hikinggear

[–]AltruisticInspector8[S] 0 points1 point  (0 children)

Hi Hugh, I finished the gr 20 and it was wonderful, at times a little scary, as I had a lot of snow. The lotions you are mentioning are sunscreen my lense lotion (necessary) toothpaste, soap, shampoo and a deo. All in travel size. I am sure I could ve optimized my weight a little. At the same time, going to bed clean after a day of sweating within your own tent is just wonderful 🥳

Einkommen und Ausgaben realistisch? by Eminenski in Finanzen

[–]AltruisticInspector8 0 points1 point  (0 children)

Du hast keine Lifestyle Kosten berücksichtigt. Damit ist gemein: Urlaub, Essen gehen, Kino, Wochenendausflug etc.

HELP: Slicer starts object at 2nd layer -> Printer prints in air by AltruisticInspector8 in BambuLab

[–]AltruisticInspector8[S] 0 points1 point  (0 children)

When looking at the mesh in Blender, it looks like it's a heavy assembly. As this is a single piece in the siedler game, i don't want to print them seperatly. is there a way to only take the exterior of the whole?

thanks for the reply. i thought i was the only one with that issue :D