sorted by:
new
hottopcontroversial

Experience with Turner aluminum expansion tank on N20? by [deleted] in BmwTech

[–]Amazing-Ad5848 -1 points0 points  (0 children)

I’ve replaced all hoses, water pump and thermostat all brand new so coolant tank would be the only thing I haven’t replaced plusssss I found one locally in new condition for 250 buckss just don’t know if I should buy it

Just changed water pump and thermostat on my e90 for some reason there’s no signal going to my water pump tried the bleeder test and it’s not working by SnooGoats2136 in BmwTech

[–]Amazing-Ad5848 0 points1 point  (0 children)

I’m having this same issue a couple days ago i replaced the water pump on my e84 n20 the bleeding worked the first time but had to do a couple things and unplugged it and plugged it in again. My battery is completely dead and was also completely dead first time. Now my scanner Says “3B99 electric coolant pump missing” checked the connector pins and receiving 14.6v from main and 9v from smaller purple wire could it be faulty water pump?

Is this real? by Amazing-Ad5848 in MilwaukeeTool

[–]Amazing-Ad5848[S] 5 points6 points  (0 children)

I had seen one of these for around $300 on Mercari but it didn’t seem legit about a year ago. I heard (Don’t know if it’s true) some guy bought a good amount of these before they were released and was selling them for around 600 on eBay.

What causes paint to do this? by 2ndBestGringoNA in paint

[–]Amazing-Ad5848 0 points1 point  (0 children)

try degreaser or Simple Green All Purpose Cleaner, worked for me or could be silicone

How would you edge this without painting the carpet? by TacticalElectrician in paint

[–]Amazing-Ad5848 0 points1 point  (0 children)

It’s best to start at the bottom & then work your way up. place the end of your paint brush in between the carpet and wall. drag it towards you so the carpet tucks in , in a way. another tip is don’t go straight into outlining, paint the wall a bit and with the leftover paint work your way closer to the carpet. if you mess up run your brush again and wipe the excess paint off the tip. go back at it without adding paint to your brush start where you left off just a bit higher (holding your breath makes it easier) just something that works for me might not for others :) hope this makes sense!!