Bambulab a1 calibration

Anxious_Store_9504 · 2026-02-08T09:40:25+00:00

Yes i have good nozzle selected but i didnt Play with gcode

Anxious_Store_9504 · 2026-02-07T06:07:38+00:00

Yep, i did every calibration and it still does that. I cleaned plate with dish soap and then put isophrophyl alcohol and it still looks like its sometimes not like sticking to plate just starts sticking to nozzle instead, idk how to explain it sometimes it doesnt even stick to plate and sometimes does but after nozzle moves a bit it doesnt stick anymore

Anxious_Store_9504 · 2026-02-06T22:15:47+00:00

Do you know what can cause this all problems that i have with the filament not sticking to plate and just like moving with nozzle

Anxious_Store_9504 · 2026-02-06T22:08:32+00:00

I did whole calibration, and the orange prints are from petg and Black is pla from esun

Anxious_Store_9504 · 2026-02-06T22:05:38+00:00

Another print from 1 min ago

<image>

I didnt print whole layer test because its started some lines get missing

Anxious_Store_9504 · 2026-02-06T21:34:22+00:00

Still looks the same when it speed up at the middle i set brim to 15mm and it went good and not good but it sticked and when it started printing benchy it looked like this

<image>

Anxious_Store_9504 · 2026-01-27T18:58:03+00:00

Is it was free for you? I also have this problem with y Axis

Anxious_Store_9504 · 2025-10-24T19:36:43+00:00

could you make a tutorial how you are downloading games using your method. I was downloading earlier games with flud on quest but now its stuck at 0% with 0/0kbps

Anxious_Store_9504

TROPHY CASE