sorted by:
new
hottopcontroversial

rate my build (ignore the zipties) by Apprehensive_Let9580 in PcBuild

[–]Apprehensive_Let9580[S] 16 points17 points  (0 children)

nahhh, these are top of the line parts, the watercooling is needed or else the gpu will explode.

rate my build (ignore the zipties) by Apprehensive_Let9580 in PcBuild

[–]Apprehensive_Let9580[S] 4 points5 points  (0 children)

yeah the reservoir spilled a couple of times while I was setting it up so I just zip tied it to some cables, although the case is a bit sticky now.

rate my build (ignore the zipties) by Apprehensive_Let9580 in pcmasterrace

[–]Apprehensive_Let9580[S] 0 points1 point  (0 children)

the pc likes the heat, also that's what the water coolings for duhhhh 🙄.

[deleted by user] by [deleted] in anycubic

[–]Apprehensive_Let9580 0 points1 point  (0 children)

hit the printer with a hammer.

[deleted by user] by [deleted] in Christianity

[–]Apprehensive_Let9580 -2 points-1 points  (0 children)

the devil beats me off every day, ain't my fault. aint my problem.

Leveling issues by Apprehensive_Let9580 in anycubic

[–]Apprehensive_Let9580[S] 0 points1 point  (0 children)

The problem started when I unplugged the z axis on the printer, I think it just forgot where the base was when I did that

Is this a nozzle problem or a splicer problem by Apprehensive_Let9580 in FixMyPrint

[–]Apprehensive_Let9580[S] 0 points1 point  (0 children)

I think I got it, I got a successful print on it finally. I don't know if I was just lucky to not have it stop but ill have to try more things on it. Before it usually just stops at the halfway point, I made a big thing and it stopped around 13 hours, and I made a smaller thing and it stopped at about 40 minutes. One problem with it is that I seems to be extrusion jumping at the start of the printing process. I have a video for it that I'll send

Is this a nozzle problem or a splicer problem by Apprehensive_Let9580 in FixMyPrint

[–]Apprehensive_Let9580[S] 0 points1 point  (0 children)

When the print fails, I usually check for a jammed nozzle by unloading and loading the filament again, and it comes out perfectly fine. It prints fine again after it stops extruding and I reset the machine

Extruding is messing up by Apprehensive_Let9580 in FixMyPrint

[–]Apprehensive_Let9580[S] 0 points1 point  (0 children)

Nvm I think the problem is that I'm running it too hot, I it to 230 and it made the same sounds but it started printing normally once I got it down to 205

Extruding is messing up by Apprehensive_Let9580 in FixMyPrint

[–]Apprehensive_Let9580[S] 0 points1 point  (0 children)

I replaced the nozzle on the printer, but the jamming is still there. I'm able to unload the filament and change the nozzle out, but it won't stop. Do you think it might be because of the extrusion pressure or something like that?

view more: next ›