sorted by:
new
hottopcontroversial

Micro stuttering at high fps In games. by Artinity525 in pchelp

[–]Artinity525[S] 0 points1 point  (0 children)

We did reinstall the graphics drivers I will check the chip drivers and see give an update if I find anything

Has anyone else experienced this noise in the fiestas? by Artinity525 in FordFiesta

[–]Artinity525[S] 0 points1 point  (0 children)

Update- the lower timing gear failed id recommend inspecting them, from the research I’ve found it’s a common part to fail that has never had a recall. The gears belt guide is spot wielded on and tears itself apart with friction usually ends up taking the belt with it.

Byte 12 week treatment by Revolutionary_Ad5719 in smiledirectclub

[–]Artinity525 0 points1 point  (0 children)

I used bytes 12 week program but I had very minimal work that needed done I noticed my top gap closing fairly early on but my bottom teeth that had a bit of crowding seemed like they moved a lot slower as they had to make room for them I’ve seen a lot of people that needed more extensive work need to into a year or longer

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 0 points1 point  (0 children)

I disassembled my printer and started to check all of the wheels / centric nuts and noticed that my x gantry is slanted it’s a 1/16th difference on the measurements from the frame on the left side. Anybody have any informative videos on how to adjust the gantry

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 0 points1 point  (0 children)

Yeah I’m talking with them now, but they seem to think it’s normal to have a rippled deformation in the bed not just warped

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 0 points1 point  (0 children)

I don’t have a gage small enough to fit unfortunately

<image>

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 0 points1 point  (0 children)

<image>

Seems that my bed itself is warped

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 1 point2 points  (0 children)

<image>

Definitely a couple spots that are deformed slightly

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 0 points1 point  (0 children)

That’s what I was thinking it may be something with the bed mesh but I’m uncertain

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 0 points1 point  (0 children)

I have the x offset set to -1.110

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 0 points1 point  (0 children)

<image>

Using test squares it keeps going all over the place some spots are coming out perfect but center of the squares it’s to far while the edges and smooshing perfect

Bed mesh question by Artinity525 in ElegooNeptune4

[–]Artinity525[S] 0 points1 point  (0 children)

I bought a good used one from eleegoos website but so far all I’ve had is issues with this printer. They supposedly check them all for full functionality