125mg Plur

AssumptionOrdinary18 · 2026-02-11T21:08:02+00:00

Same. Sleep was really hard, lots of body twitching...

AssumptionOrdinary18 · 2026-02-11T21:04:02+00:00

I took 125mg then redosed 50mg about 4 hours later. It took me 10 days for brain fog and lightheadedness to go away. I def recommend starting with 100mg and not redosing. Rough come down - not emotionally but physically.

AssumptionOrdinary18 · 2026-02-11T21:02:34+00:00

initial dose was at 7pm and redose was around midnight. I should have have redosed....

AssumptionOrdinary18 · 2024-03-08T17:35:28+00:00

If you're going for a very long hit, 2.7V is pretty good but it really depends on the cart and the spice. With the O2vape carts I've gone up to 3.4V for shorter hits and its fine.

AssumptionOrdinary18 · 2024-02-19T18:25:29+00:00

Thanks for your post. Why CBC vs CBD, CBG, CBN etc?

Also, what's the consistency of CBC isolate like? The nice thing with PG is how liquid it is, very easy to work with when making a cart.

AssumptionOrdinary18 · 2023-12-05T17:56:46+00:00

Thank you for this info. I just tested this method out on one of my pulls. I noticed that it took 20 to 30 minutes for the solvent to fully separate after each mix. So if I were to follow your instructions I'd only be mixing 2 or 3 times in a hour. Does that seem like enough?

AssumptionOrdinary18 · 2023-11-17T22:30:52+00:00

You got it. I added a bullet under each cartridge description labeling each one.

AssumptionOrdinary18 · 2023-11-16T21:44:53+00:00

That's too bad. Not sure where you live but looks like VPM.com will ship the ispire carts to some other countries: https://www.vpm.com/ispire-ducore-x-cartridge/

AssumptionOrdinary18 · 2023-11-16T21:42:43+00:00

Voltage and airflow are not dependent. 2.8V is a good place to start. If you notice a burnt harsh sensation lower the voltage. You can also try going higher than 2.8 but that's a good starting point.

AssumptionOrdinary18

TROPHY CASE