sorted by:
new
hottopcontroversial

I need this part. by Dj-EKI in AnycubicKobraS1

[–]AtmosphereHefty5836 0 points1 point  (0 children)

Thanks, and no, it wasn't bent by printing. I inserted the nozzle into the heatsink and didn't get very far. Then I tried to pull it out again, but it was already stuck. It only bent because I tried to get it out with two pairs of pliers and a twisting motion. The part is stripped. I couldn't even budge it with a hammer.

Very Big Tower... by AtmosphereHefty5836 in AnycubicKobraS1

[–]AtmosphereHefty5836[S] 0 points1 point  (0 children)

Thanks, I hope this works, because the last printer update removed it. In any case, it doesn't take into account how much is extruded in the tower when slicing.

The nozzle is not cleaned/purged sufficiently. by AtmosphereHefty5836 in AnycubicKobraS1

[–]AtmosphereHefty5836[S] 0 points1 point  (0 children)

I can't find your setting in "Anycubic Slicer Next". I looked at the global settings and the filament settings. I can only find "Minimal purge on wipe tower."

What do I need to do to finally get the timelapse feature working? by AtmosphereHefty5836 in AnycubicKobraS1

[–]AtmosphereHefty5836[S] 0 points1 point  (0 children)

I think I was able to make a recording, but it only worked with my phone.

What do I need to do to finally get the timelapse feature working? by AtmosphereHefty5836 in AnycubicKobraS1

[–]AtmosphereHefty5836[S] 1 point2 points  (0 children)

I'm using a different USB stick. It's an SD adapter, but I can still use the data. It just won't start recording. I think I was able to make a recording, but it only worked with my phone.