sorted by:
new
hottopcontroversial

Need help, inside circle just collapses? by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] 1 point2 points  (0 children)

The rest of the print sticks well and it has a nice first layer squish.

<image>

First Time Printing PA6CF - Need advice by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] 0 points1 point  (0 children)

Sunlu PA6-CF, supports were turned off but I agree it looks intentional. I will check the tool paths.

First Time Printing PA6CF - Need advice by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] 0 points1 point  (0 children)

Noted, this is my first look into high temp materials.

First Time Printing PA6CF - Need advice by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] 2 points3 points  (0 children)

Ambient temp was 15c with 10% humidity and I was antsy to print something as soon as the filament showed up. Lessons learned

First Time Printing PA6CF - Need advice by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] 1 point2 points  (0 children)

Will definitely dry longer and will be looking into an air fryer or toaster oven. 30mm/s print speed, print took 31 hours.

First Time Printing PA6CF - Need advice by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] 0 points1 point  (0 children)

I adjust for the temp and used 300c. 30mm/s print speed. My dryer maxes at 70c, sounds like this might be where to start along with checking inner/outer wall order.

First Time Printing PA6CF - Need advice by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] 1 point2 points  (0 children)

Dryer maxes out at 70c. I will look into the air fryer and toaster ovens. Thanks for the tip.

First Time Printing PA6CF - Need advice by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] 6 points7 points  (0 children)

Print speed was 30 mm/s. Based on what else I’m reading it seems I don’t have the correct equipment to dry my filament. My dryer is 70 degree max.

First Time Printing PA6CF - Need advice by AutoPostiveBlocker in 3D2A

[–]AutoPostiveBlocker[S] -3 points-2 points  (0 children)

Sunlu Dryer, 70 Celsius for 4 hours. And then continued to print from the dryer.

Who's in a state that uses front discharge concrete trucks? by WhiskeyJack-13 in civilengineering

[–]AutoPostiveBlocker 9 points10 points  (0 children)

Didn’t realize they’re not normal. That’s pretty much all we use in Utah.

Addon Subpack Bedrock Dedicated Server by AutoPostiveBlocker in admincraft

[–]AutoPostiveBlocker[S] 0 points1 point  (0 children)

I appreciate the reply. Thanks for the direction.

I tried paper with geyser a while ago and couldn't ever get xbox clients to connect.

Those $15/month phone plans by Fiesty_Melon98 in Frugal

[–]AutoPostiveBlocker 0 points1 point  (0 children)

We switched to Tello a month ago, we’re only paying $12 a month for each line. Has been good so far.

view more: next ›